Effect of particulate fillers on mechanical and abrasive wear behaviour of polyamide 66/polypropylene nanocomposites
Authors:
- B. SureshaBSB. Suresha
- 1 October 2009
- journal article
- Published by Elsevier in Materials & Design (1980-2015)
- Vol. 30 (9) , 3852-3858
Abstract
No abstract availableKeywords
This publication has 25 references indexed in Scilit:
- Mechanical and three‐body abrasive wear behaviour of SiC filled glass‐epoxy compositesPolymer Composites, 2008
- Three-body abrasive wear behaviour of carbon and glass fiber reinforced epoxy compositesMaterials Science and Engineering: A, 2007
- Friction and Wear Performance Evaluation of Carbon Fibre Reinforced PTFE CompositeJournal of Reinforced Plastics and Composites, 2002
- Frictional Properties of Nylons Slid against Alumina Ceramics in Water.Journal of The Japan Petroleum Institute, 1996
- Tribology and Morphology of Crystalline Polymers.Journal of The Japan Petroleum Institute, 1995
- Influence of reinforcement and lubrication on abrasive wear performance of polyamideJournal of Synthetic Lubrication, 1991
- Phase morphology of injection‐molded blends of nylon‐6 and polyethylene and comparison with compression moldingPolymer Engineering & Science, 1991
- An investigation of instability of phase morphology of blends of nylons with polyethylenes and polystyrenes and effects of compatibilizing agentsPolymer Engineering & Science, 1988
- The abrasive wear behaviour of continuous fibre polymer compositesJournal of Materials Science, 1987
- Mechanical properties of particulate filled polymersPolymer Composites, 1987