A Neural Network-based Low-cost Soft Sensor for Touch Recognition and Deformation Capture
Open Access
- 10 July 2023
- conference paper
- Published by Association for Computing Machinery (ACM)
- p. 889-903
Abstract
We propose a novel, cost-effective soft sensor capable of detecting contact force, multiple touch points, and reflecting sensor interaction in real-time with a 3D virtual surface representation. Our fabrication process has been optimized for cost efficiency through careful material selection, utilization of automated machinery, and low-cost hardware. The sensor can be easily replicated without the need for complex laboratory equipment. The sensor employs trained neural network models for real-time signal translation into localization, force measurement, and deformation mapping. We have also developed an efficient data collection system that captures accurate 2D localization, force measurement, and 3D surface data to generate a high-quality pre-validated data set. This data set is filtered using prior knowledge before being fed to two neural network models. Our interactive prototype demonstrates the stability and accuracy of the low-cost soft sensor, delivering reliable results in both single-point and multi-point contact scenarios.Keywords
This publication has 59 references indexed in Scilit:
- High-Resolution, Large-Area Fabrication of Compliant Electrodes via Laser Ablation for Robust, Stretchable Dielectric Elastomer Actuators and SensorsACS Applied Materials & Interfaces, 2015
- A Layered Fabric 3D Printer for Soft Interactive Objects2015
- Deformable Interfaces for Performing Music2015
- iSkin2015
- Inviz: Low-power personalized gesture recognition using wearable textile capacitive sensor arrays2015
- Gait Analysis for Fall Prediction Using Hierarchical Textile-Based Capacitive Sensor Arrays2015
- Recognition of Bed Postures Using Mutual Capacitance Sensing2014
- FlexSense2014
- Stretchable active-matrix organic light-emitting diode display using printable elastic conductorsNature Materials, 2009
- DO-IT: deformable object as input tool for 3-D geometric operationComputer-Aided Design, 2000