On the fabrication of PDMS micromodels by rapid prototyping, and their use in two‐phase flow studies
Open Access
- 18 March 2013
- journal article
- research article
- Published by American Geophysical Union (AGU) in Water Resources Research
- Vol. 49 (4) , 2056-2067
Abstract
No abstract availableKeywords
Funding Information
- German Research Foundation (DFG)
- the Netherlands Organization for Scientific Research (NWO) (818.01.008)
This publication has 48 references indexed in Scilit:
- Hysteresis and interfacial energies in smooth‐walled microfluidic channelsWater Resources Research, 2011
- Microchannel deformations due to solvent-induced PDMS swellingLab on a Chip, 2010
- Network model investigation of interfacial area, capillary pressure and saturation relationships in granular porous mediaWater Resources Research, 2010
- Development of RIE‐lag Reduction Technique for Si Deep Etching Using Double Protection Layer MethodIEEJ Transactions on Electrical and Electronic Engineering, 2010
- Flow-induced deformation of shallow microfluidic channelsLab on a Chip, 2006
- Crossover from capillary fingering to viscous fingering for immiscible unstable flow: Experiment and modelingPhysical Review E, 2004
- Visualization and Modeling of Polystyrol Colloid Transport in a Silicon MicromodelVadose Zone Journal, 2004
- Rapid Prototyping of Microfluidic Systems in Poly(dimethylsiloxane)Analytical Chemistry, 1998
- Steady-state two-phase flow through planar and nonplanar model porous mediaTransport in Porous Media, 1994
- Thermodynamic basis of capillary pressure in porous mediaWater Resources Research, 1993