Microstructure and Impact Wear Resistance of TiN Reinforced High Manganese Steel Matrix
Authors:
- You-Ping MaYMYou-Ping Ma
- Xiu-Lan LiXLXiu-Lan Li
- Cheng-Hui WangCWCheng-Hui Wang
- Lu LuLLLu Lu
- 1 July 2012
- journal article
- Published by Springer Nature in Journal of Iron and Steel Research International
- Vol. 19 (7) , 60-65
Abstract
No abstract availableKeywords
This publication has 10 references indexed in Scilit:
- The abrasive wear resistance of TIC and (Ti,W)C-reinforced Fe–17Mn austenitic steel matrix compositesTribology International, 2010
- Microstructural and mechanical characterization of in situ TiC and (Ti,W)C-reinforced high manganese austenitic steel matrix compositesMaterials Science and Engineering: A, 2009
- Microstructure and abrasive wear study of (Ti,W)C-reinforced high-manganese austenitic steel matrix compositeMaterials Letters, 2008
- The threshold pressure of infiltration into fibrous preforms normal to the fibers’ axesComposites Science and Technology, 2008
- Patterned PVD TiN spot coatings on M2 steel: Tribological behaviors under different sliding speedsWear, 2006
- An infiltration model based on flow variability in macropores: development, sensitivity analysis and applicationsJournal of Hydrology, 2005
- Mechanical properties and electrical conductivity of TiN–Al2O3 nanocompositesJournal of the European Ceramic Society, 2003
- Adhesion strength and high temperature wear behaviour of ion plating TiN composite coating with electric brush plating NiW interlayerSurface and Coatings Technology, 2001
- Influence of the metal/ceramic interface on the microstructure and mechanical properties of HIPed iron-based compositesComposites Science and Technology, 1996
- On the improvement of the performance of high speed steel turning tools by tin coatingsWear, 1987