Stacking fault model of ∊-martensite and itsDIFFaXimplementation
- 28 June 2011
- journal article
- research article
- Published by International Union of Crystallography (IUCr) in Journal of Applied Crystallography
- Vol. 44 (4) , 779-787
Abstract
Plastic deformation of highly alloyed austenitic transformation-induced plasticity (TRIP) steels with low stacking fault energy leads typically to the formation of ∊-martensite within the original austenite. The ∊-martensite is often described as a phase having a hexagonal close-packed crystal structure. In this contribution, an alternative structure model is presented that describes ∊-martensite embedded in the austenitic matrixviaclustering of stacking faults in austenite. The applicability of the model was tested on experimental X-ray diffraction data measured on a CrMnNi TRIP steel after 15% compression. The model of clustered stacking faults was implemented in theDIFFaXroutine; the faulted austenite and ∊-martensite were represented by different stacking fault arrangements. The probabilities of the respective stacking fault arrangements were obtained from fitting the simulated X-ray diffraction patterns to the experimental data. The reliability of the model was proven by scanning and transmission electron microscopy. For visualization of the clusters of stacking faults, the scanning electron microscopy employed electron channelling contrast imaging and electron backscatter diffraction.Keywords
This publication has 32 references indexed in Scilit:
- Is there a relationship between the stacking fault character and the activated mode of plasticity of Fe–Mn-based austenitic steels?Scripta Materialia, 2009
- A molecular dynamics study of the fcc→bcc transformation at fault intersectionsActa Materialia, 2008
- Stacking and twin faults in close-packed crystal structures: exact description of random faulting statistics for the full range of faulting probabilitiesActa Crystallographica Section A Foundations of Crystallography, 2008
- Ab initiostudy of the bcc-hcp transformation in ironPhysical Review B, 2008
- Influence of planar defects on powder diffractograms of fcc metalsPowder Diffraction, 2002
- On the origin of deformation microstructures in austenitic stainless steel: Part II—MechanismsActa Materialia, 2001
- On the origin of deformation microstructures in austenitic stainless steel: part I—microstructuresActa Materialia, 2001
- Dislocations, grain size and planar faults in nanostructured copper determined by high resolution X-ray diffraction and a new procedure of peak profile analysisActa Materialia, 1998
- The crystallographic relationship between the phases γ and ε in the system iron–manganeseActa Crystallographica, 1952
- ber den Mechanismus der Stahlh rtungThe European Physical Journal A, 1930