Buckling of Restrained Monosymmetric Rings
Authors:
- 1 October 1988
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Engineering Mechanics
- Vol. 114 (10) , 1651-1671
Abstract
Rings are commonly used at junctions between shell segments in pressure vessels, tanks, and silos. Often the ring is in circumferential compression and is susceptible to failure by buckling. This buckling is usually restrained by the adjacent shell segments, which prevent translation and elastically restrain rotation of the point of attachment. The ring is normally not loaded at its centroid or shear center. This paper presents an analysis of the buckling of a monosymmetric ring under these conditions. Four versions of the theory are presented, which make progressively less restrictive assumptions relating to the ring as a “thin ring.” The analytical predictions are compared with numerical stability assessments from a finite element shell buckling analysis. The classical thin ring solution is shown to be satisfactory for most practical purposes.Keywords
This publication has 6 references indexed in Scilit:
- Erratum: “Flexural-Torsional Buckling of Arches”Journal of Structural Engineering, 1987
- Flexural-Torsional Stability of Curved BeamsJournal of the Engineering Mechanics Division, 1982
- Effect of Shear and Load Behavior on Ring StabilityJournal of the Engineering Mechanics Division, 1969
- Buckling of thin circular rings under uniform pressureInternational Journal of Solids and Structures, 1967
- Bending and Buckling of Thin-Walled Open-Section RingsJournal of the Engineering Mechanics Division, 1963
- Nonlinear theories for thin shellsQuarterly of Applied Mathematics, 1963