Effect of the shot peening process on the fatigue strength of SAE 5160 steel
- 5 December 2018
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
- Vol. 233 (12) , 4328-4335
Abstract
The fatigue behaviour of SAE 5160 steel was evaluated before and after applying a shot peening process by using different Almen intensities and surface coverings (uncovered, partial coverage and total coverage). In the high-cycle fatigue tests, maximum stresses of 0.8 Sut, 0.7 Sut and 0.6 Sut were applied in the three-point bending test on an Instron 8872 servo-hydraulic machine at a frequency of 10 Hz and a constant stress ratio of Smin/ Smax = 0.2 for all tests. The fatigue tests were performed based on the ASTM E8, the specimens were classified into six groups for each stress evaluated, and each group consisted of three standardised specimens (ASTM E466). Also, yield strength, ultimate strength, hardness and microhardness were obtained. The Wilcoxon’s non-parametric test was used to statistically compare all the mechanical properties obtained from the base material with those obtained after the application of the shot peening, for the different surface coverings and Almen intensities. The results showed that the shot peening process significantly increases the fatigue strength of the material, with a 94% increase in fatigue strength of the fully coated specimens. However, no significant increase in fatigue strength was found due to a change in the Almen intensity value. A high correlation factor was found between the increase in the ultimate resistance and the increase in Almen intensity; however, for the yield stress the correlation was medium and inverse. For hardness and microhardness, the correlation factor was very low. Finally, the microhardness values revealed a 3% increase in Vickers microhardness of the shot peening specimens compared to the untreated specimens.Keywords
This publication has 12 references indexed in Scilit:
- The impact of heat treatment and shot peening on the fatigue strength of 51CrV4 steelProcedia Structural Integrity, 2016
- Effects of microshot peening on surface characteristics of high-speed tool steelJournal of Materials Processing Technology, 2008
- ‘Shotgun’ method can improve PM steel fatigue lifeMetal Powder Report, 2004
- When fatigue quality enhancers do not enhance fatigue qualityInternational Journal of Fatigue, 2003
- The Effect of Shot Peening Coverage on Residual Stress, Cold Work and Fatigue in a Ni‐Cr‐Mo Low Alloy Steel2003
- Shot Peening2003
- Enhancement of fatigue strength of SAE 9245 steel by shot peeningMaterials Letters, 2002
- An evaluation of shot peening, residual stress and stress relaxation on the fatigue life of AISI 4340 steelInternational Journal of Fatigue, 2002
- Effect of shot-peening treatment on high cycle fatigue property of ductile cast ironInternational Journal of Fatigue, 2001
- Surface modifications induced in 316L steel by laser peening and shot-peening. Influence on pitting corrosion resistanceMaterials Science and Engineering: A, 2000