Failure mechanisms of 2‐D and 3‐D woven fiber reinforced polymer composites
Authors:
- 1 April 1995
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 16 (2) , 125-134
Abstract
A simple lab‐scale weaving method was used to produce multidirectional fiber preforms to improve the delamination resistance and damage tolerance of composites. Mechanical properties measured in this study included short‐beam shear strength and damage tolerance of 2‐D and 3‐D woven composites. The constituents of fiber and matrix in these composites are Kevlar‐29 (Du Pont) and Epon 828 (Shell Chemical Co.) epoxy. Attention was directed to the differentiation of deformation and failure mechanisms in these composites as a function of material parameters and loading conditions. The sequence of failure mechanisms differ between 2‐D and 3‐D composites. Results indicated that 3‐D woven composites exhibited higher shear strength than 2‐D woven composites. Also, 3‐D composites absorbed more impact energy than 2‐D composites. Failure mechanisms of composites subjected to repeated impacts were observed intermittently by using scanning electron microscopy and light microscopy. The failure of 2‐D composites was due to a combination of shear and tensile mode, but in 3‐D composites the failure was dominated by tensile mode.Keywords
This publication has 8 references indexed in Scilit:
- Fracture behavior in stitched multidirectional compositesMaterials Science and Engineering: A, 1989
- Influence of Cyclic Load Amplitude on Damage Accumulation and Fracture of Composite LaminatesJournal of Composites Technology and Research, 1988
- A Comparison of Several Mechanical Tests Used to Evaluate the Toughness of Composites1987
- The Effect of Resin Toughness and Modulus on Compressive Failure Modes of Quasi-Isotropic Graphite/Epoxy Laminates1987
- Damage Tolerance of Toughened Resin Graphite Composites1987
- Impact Fatigue of Polymers Using an Instrumented Drop Tower Device1986
- Impact fatigue response of ultra-high molecular weight linear polyethyleneJournal of Materials Science, 1979
- The Laminate Analogy for 2 and 3 Dimensional Composite MaterialsJournal of Composite Materials, 1971