Microstructure and Mechanical Properties of Nickel-Based Coatings Fabricated through Laser Additive Manufacturing
Open Access
Abstract
In this study, single-layer and three-layer nickel-based coatings were fabricated on 316L SS by laser additive manufacturing. The phase characterization, microstructure observation, and microhardness analysis of the coatings were carried out by X-ray diffraction (XRD), scanning electron microscope (SEM), and microhardness tester. And the wear resistance of the coatings was analyzed through dry sliding friction and wear test. The results show that the cross-section microstructure of the three-layer nickel-based coating is different from that of the single-layer one under the influence of heat accumulation; the dendrite structure in the central region of the former is equiaxial dendrite, while that of the latter still remains large columnar dendrites. The existence of solid solution phase γ-(Fe, Ni) and hard phases of Ni17Si3, Cr5B3, Ni3B in the coating significantly improve the wear resistance of the coating, and the microhardness is nearly 2.5 times higher than that of the substrate. However, the average microhardness of multilayer cladding coating is about 48 HV0.2 higher than that of the single-layer cladding coating. In addition, the fine surface structure of the three-layer nickel-based coating improves the wear resistance of the coating, making this coating with the best wear resistance.Keywords
This publication has 41 references indexed in Scilit:
- Effects of geometric dimension and grain size on impact properties of 316L stainless steelMaterials Letters, 2021
- Corrosion resistance of additively manufactured 316L stainless steel in chloride−thiosulfate environmentElectrochimica Acta, 2020
- Effects of Fe–Al intermetallic compounds on the wear and corrosion performances of AA2024/316L SS metal/metal compositesJournal of Alloys and Compounds, 2020
- Comparison of microstructure and oxidation behavior of CoNiCrAlY coatings produced by APS, SSAPS, D-gun, HVOF and CGDS techniquesVacuum, 2020
- Laser cladding of TiC reinforced 316L stainless steel composites: Feedstock powder preparation and microstructural evaluationPowder Technology, 2020
- Microstructure and mechanical properties of TA15-Ti2AlNb bimetallic structures by laser additive manufacturingMaterials Science and Engineering: A, 2020
- Microstructure and properties of Ti–Zr congruent alloy fabricated by laser additive manufacturingJournal of Alloys and Compounds, 2020
- Laser cladding process of Cobalt and Nickel based hard-micron-layers on 316L-stainless-steel-substrateMaterials and Manufacturing Processes, 2019
- A new precursor for fabricating TiN coating on 316L stainless steel at low temperature without corrosive byproductsCeramics International, 2019
- Laser additive manufacturing of structural-graded bulk metallic glassJournal of Alloys and Compounds, 2018