Effect of porosity gradient in cathode gas diffusion layer of polymer electrolyte membrane fuel cells on the liquid water transport using lattice Boltzmann method
- 25 June 2020
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy
- Vol. 235 (3) , 546-562
Abstract
In this paper, a two-dimensional model has been developed to simulate the liquid water transport in a cathode gas diffusion layer with different porosity gradients in polymer electrolyte membrane fuel cells (PEMFCs). Due to the complexity of porous media, the simulation was carried out by lattice Boltzmann method. According to dimensionless numbers that characterize liquid water transport in porous media, simulation conditions were similar to the liquid water transfer into the gas diffusion layer of PEMFC. Different gas diffusion layers were created randomly by solid circular particles with an average diameter of and the numerical code was validated by conducting several tests. The results indicated that capillary force is the main factor in liquid water transport in the gas diffusion layer, while viscous and gravitational forces do not have a significant effect. In addition to improve the water management, the gas diffusion layer should have a positive porosity gradient, i.e. the porosity increases along the thickness. Also, under the same boundary conditions and at the average porosity (0.659), the saturation distribution curves in three porous media were compared including the gas diffusion layer with porosity gradient, the gas diffusion layer with the micro-porous layer, and the gas diffusion layer with uniform porosity. The average liquid water saturation in the gas diffusion layer with the 10% porosity gradient was 20.2% lower than in the gas diffusion layer with uniform porosity and 10.5% lower than the gas diffusion layer + micro-porous layer. Furthermore, upon elevation of the porosity gradient in the gas diffusion layer, the average liquid water saturation in the gas diffusion layer decreased. Specifically, as the porosity gradient rose from 10% to 14% and 18.5%, the average liquid water saturation values decreased to 29.8% and 38.8%, respectively compared with the gas diffusion layer with uniform porosity.
Keywords
This publication has 44 references indexed in Scilit:
- Partial flooding and its effect on the performance of a proton exchange membrane fuel cellEnergy Conversion and Management, 2020
- A FLOW CHANNEL WITH NAFION MEMBRANE MATERIAL DESIGN OF PEM FUEL CELLJournal of Thermal Engineering, 2019
- Techno‐economic Analysis of a More Efficient Hydrogen Generation System Prototype: A Case Study of PEM Electrolyzer with Cr‐C Coated SS304 Bipolar PlatesFuel Cells, 2019
- Energy and exergy analyze of PEM fuel cell: A case study of modeling and simulationsEnergy, 2018
- Numerical investigation of liquid water transport and distribution in porous gas diffusion layer of a proton exchange membrane fuel cell using lattice Boltzmann methodRussian Journal of Electrochemistry, 2012
- Prediction of Dry-Wet-Dry Transition in Polymer Electrolyte Fuel CellsJournal of the Electrochemical Society, 2007
- Effects of porosity distribution variation on the liquid water flux through gas diffusion layers of PEM fuel cellsJournal of Power Sources, 2006
- Transient analysis for the cathode gas diffusion layer of PEM fuel cellsJournal of Power Sources, 2006
- A 3D, Multiphase, Multicomponent Model of the Cathode and Anode of a PEM Fuel CellJournal of the Electrochemical Society, 2003
- Fundamental thermodynamics of fuel cell, engine, and combined heat and power system efficienciesProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2002