Laser‐Induced Carbonization of Natural Organic Precursors for Flexible Electronics
Open Access
- 3 September 2020
- journal article
- research article
- Published by Wiley in Advanced Electronic Materials
- Vol. 6 (10)
Abstract
A precursor ink for carbon laser‐patterning is developed using inexpensive, naturally abundant molecular compounds, namely citric acid and urea, and used to fine‐print conductive carbon circuits on a flexible substrate. The precursor in the ink consists of organic nanoparticles obtained from the thermal treatment of citric acid and urea. This precursor is thoroughly characterized chemically and structurally. A simple recipe for the ink is then described for the creation of highly reproducible laser‐patterned carbon structures on different substrates. Homogeneous ∼20 µm thick films are cast on different substrates and characterized before and after laser‐carbonization. The carbon content of the final films is 97% and is of turbostratic graphitic nature. As reproducible laser‐induced reactions depend on precise laser conditions, the influence of material properties, film thickness, and laser fluence are thoroughly analyzed. Films on three different substrates, namely aluminum sheets, silicon wafers, and polyethylene terephthalate (PET) are characterized by electrical impedance measurements. Electrical conductivities of up to 5.21 S cm−1 and maximum current densities of 44 A cm−2 are achieved, which proved applicable as fine carbon circuits on PET as a flexible substrate. This study opens a simple synthetic avenue to producing conductive circuit elements based on carbon.Keywords
This publication has 32 references indexed in Scilit:
- Excimer laser reduction and patterning of graphite oxideCarbon, 2013
- Carbon Nanotubes: Present and Future Commercial ApplicationsScience, 2013
- Reduction of graphite oxide to graphene with laser irradiationCarbon, 2013
- Introduction to Laser Assisted Fabrication of Materials2012
- Patterning and Electronic Tuning of Laser Scribed Graphene for Flexible All-Carbon DevicesACS Nano, 2012
- Direct laser writing of micro-supercapacitors on hydrated graphite oxide filmsNature Nanotechnology, 2011
- Formation of Graphene Features from Direct Laser-Induced Reduction of Graphite OxideThe Journal of Physical Chemistry Letters, 2010
- Raman spectroscopy in graphenePhysics Reports, 2009
- Carbonization of polyimide film “Kapton”Carbon, 1989
- Polyimides as precursors for artificial carbonCarbon, 1975