Characterizing Hydraulic Conductivity with the Direct‐Push Permeameter
- 12 March 2007
- journal article
- Published by Wiley in Groundwater
- Vol. 45 (4) , 409-419
Abstract
The direct‐push permeameter (DPP) is a promising approach for obtaining high‐resolution information about vertical variations in hydraulic conductivity (K) in shallow unconsolidated settings. This small‐diameter tool, which consists of a short screened section with a pair of transducers inset in the tool near the screen, is pushed into the subsurface to a depth at which a K estimate is desired. A short hydraulic test is then performed by injecting water through the screen at a constant rate (less than 4 L/min) while pressure changes are monitored at the transducer locations. Hydraulic conductivity is calculated using the injection rate and the pressure changes in simple expressions based on Darcy’s Law. In units of moderate or higher hydraulic conductivity (more than 1 m/d), testing at a single level can be completed within 10 to 15 min. Two major advantages of the method are its speed and the insensitivity of the K estimates to the zone of compaction created by tool advancement. The potential of the approach has been assessed at two extensively studied sites in the United States and Germany over a K range commonly faced in practical field investigations (0.02 to 500 m/d). The results of this assessment demonstrate that the DPP can provide high‐resolution K estimates that are in good agreement with estimates obtained through other means.Keywords
This publication has 28 references indexed in Scilit:
- What information can we get from pumping tests?-comparing pumping test configurations using sensitivity coefficientsJournal of Hydrology, 2006
- Tracer tests for the investigation of heterogeneous porous media and stochastic modelling of flow and transport—a review of some recent developmentsJournal of Hydrology, 2004
- A travel time based hydraulic tomographic approachWater Resources Research, 2003
- Steady shape analysis of tomographic pumping tests for characterization of aquifer heterogeneitiesWater Resources Research, 2002
- Inverse modeling of partitioning interwell tracer tests: A streamline approachWater Resources Research, 2002
- Aquifer characterisation using Surface NMR jointly with other geophysical techniques at the Nauen/Berlin test siteJournal of Applied Geophysics, 2002
- A dual-tube direct-push method for vertical profiling of hydraulic conductivity in unconsolidated formationsEnvironmental & Engineering Geoscience, 2002
- A method to estimate hydraulic conductivity while drillingJournal of Hydrology, 2002
- A mini slug test method for determination of a local hydraulic conductivity of an unconfined sandy aquiferJournal of Hydrology, 1992
- The Role of Pumping Tests in Site Characterization: Some Theoretical ConsiderationsGroundwater, 1990