Experimental Study on the Influence of Moisture and Clay Content on Stress Wave Attenuation Characteristics of Filled Joints
Open Access
- 12 September 2022
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 12 (18) , 9140
Abstract
Artificial filled joints made of sand–clay mixtures with different clay weight fractions and saturations have different wave attenuation capacities. In this paper, the high amplitude impact test of sand–clay mixtures was carried out by using split Hopkinson pressure bar (SHPB) equipment. The results showed that with the increase of clay weight fraction, the particle crushing decreased continuously, while the wave attenuation coefficient decreased first and then increased. When the weight fraction of clay was 50%, the wave attenuation coefficient reached the minimum among the tested working conditions, and the ratio of transmitted energy to incident energy reached the maximum. With the increase of saturation, the particle crushing decreased first and then increased, while the wave attenuation coefficient increased first and then decreased. When the saturation was 25%, the wave attenuation coefficient reached the maximum, and the proportion of transmitted energy to incident energy reached the minimum. Because of the lubrication of water reduced the friction between particle, the specimen more prone to deformation and particle crushing reduced. As the saturation increased, this effect gradually decreased. In the case of the wave absorbing layer of protective works, special attention should be paid to the adverse effects caused by groundwater.Keywords
Funding Information
- National Natural Science Foundation of China (NSFC) (51979280, 52009138)
This publication has 22 references indexed in Scilit:
- An SHPB test study on wave propagation across rock masses with different contact area ratios of jointInternational Journal of Impact Engineering, 2017
- Role of filling materials in a P-wave interaction with a rock fractureEngineering Geology, 2014
- Effects of particle size and moisture on the compressive behavior of dense Eglin sand under confinement at high strain ratesInternational Journal of Impact Engineering, 2014
- Effects of grain size and gradation on the dynamic responses of quartz sandsInternational Journal of Impact Engineering, 2013
- A thin-layer interface model for wave propagation through filled rock jointsJournal of Applied Geophysics, 2013
- Effect of Mass Density on the Compressive Behavior of Dry Sand Under Confinement at High Strain RatesExperimental Mechanics, 2011
- Moisture effects on the high strain-rate behavior of sandMechanics of Materials, 2009
- Analysis of Wave Propagation Through a Filled Rock JointRock Mechanics and Rock Engineering, 2009
- Determination of physicomechanical properties of soft soils from medium to high strain ratesInternational Journal of Impact Engineering, 2008
- Crushing of Soil ParticlesJournal of Geotechnical Engineering, 1985