The Influence of EP/AW Addition in the MQL Method on the Parameters of Surface Geometrical Structure in the Process of Turning 316L Steel
- 15 September 2018
- book chapter
- Published by Springer Nature
- p. 341-350
Abstract
No abstract availableKeywords
This publication has 26 references indexed in Scilit:
- Multi-sensor measurements of titanium alloy surface texture formed at subsequent operations of precision machining processMeasurement, 2017
- Structural and Microhardness Changes After Turning of the AISI 1045 Steel for Minimum Quantity Cooling LubricationJournal of Materials Engineering and Performance, 2016
- The Use of Focus-Variation Microscopy for the Assessment of Active Surfaces of a New Generation of Coated Abrasive ToolsMeasurement Science Review, 2016
- Influence of Cryogenic Cooling on Tool Wear and Chip Formation in Turning of Titanium AlloyProcedia CIRP, 2016
- Analysis of Contact Phenomena and Heat Exchange in the Cutting Zone Under Minimum Quantity Cooling Lubrication conditionsArabian Journal for Science and Engineering, 2015
- Investigation of wear and tool life of coated carbide and cubic boron nitride cutting tools in high speed millingAdvances in Mechanical Engineering, 2015
- Machining and ecological effects of a new developed cutting fluid in combination with different cooling techniques on turning operationJournal of Cleaner Production, 2015
- Sustainability Assessment: Cryogenic Machining of Inconel 718Strojniški vestnik - Journal of Mechanical Engineering, 2011
- An experimental investigation of the effects of workpiece and grinding parameters on minimum quantity lubrication—MQL grindingInternational Journal of Machine Tools and Manufacture, 2009
- Effect of minimum quantity lubrication (MQL) on tool wear and surface roughness in turning AISI-4340 steelJournal of Materials Processing Technology, 2006