Slip Recovery and Prevention in Pseudo Direct Drive Permanent-Magnet Machines
Authors:
- Mohammed BouheraouaMBMohammed Bouheraoua
- Jiabin WangJiabin Wang
- Kais AtallahKAKais Atallah
- 2 December 2014
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industry Applications
- Vol. 51 (3) , 2291-2299
Abstract
A Pseudo Direct Drive (PDD) is a permanent magnet machine with an integrated magnetic gear. It has two magnetically coupled rotors. When subjected to a load torque higher than the pull-out torque, slip between the two rotors may occur. Although this may not cause any damage to the PDD or the load, it could, if left uncontrolled, result in undesirable consequences such as loss of power transfer, excessive speed on the high-speed rotor (HSR), incorrect commutation signal, and/or loss of load speed/position control. This paper proposes a technique for a PDD equipped with a position/speed sensor on each rotor to control the slip caused by external overload torques and to enable a swift recovery when they are removed. However, when the PDD is equipped with only one sensor on the HSR, it is impossible to determine the position/speed of the low-speed rotor using an observer after slip occurs, which precludes a swift and controlled recovery. Therefore, a novel technique which prevents the slip between the two rotors under overload conditions is also proposed. Both techniques have been successfully implemented and demonstrated on a prototype PDD drive.Keywords
This publication has 15 references indexed in Scilit:
- Design and implementation of an observer‐based state feedback controller for a pseudo direct driveIET Electric Power Applications, 2013
- Speed Control of Electrical Drives Using Classical Control MethodsIEEE Transactions on Industry Applications, 2013
- A complex frequency domain analysis of a closed loop controlled pseudo direct drive2012
- Magnetic Gear Pole-Slip Prevention Using Explicit Model Predictive ControlIEEE/ASME Transactions on Mechatronics, 2012
- Magnetic gear overload detection and remedial strategies for servo-drive systems2010
- Design and analysis of a pseudo direct-drive propulsion motor2010
- Comparison of Direct-Drive and Geared Generator Concepts for Wind TurbinesIEEE Transactions on Energy Conversion, 2006
- Control of Electrical Drives2001
- Speed control of two-inertia system by PI/PID controlIEEE Transactions on Industrial Electronics, 2000
- Slow resonance ratio control for vibration suppression and disturbance rejection in torsional systemIEEE Transactions on Industrial Electronics, 1999