Effect of Ionomer Dispersibility on Membrane Electrode Assembly for Direct Methanol Fuel Cell
Authors:
Open Access
- 5 December 2002
- journal article
- Published by The Electrochemical Society of Japan in Electrochemistry
- Vol. 70 (12) , 931-933
Abstract
The effect of Nafion loading with spray treatment in the catalyst layer for the Direct Methanol Fuel Cell (DMFC) was investigated. The spray treatment of the membrane electrode assembly (MEA) was effective, and improved the short circuit current up to 378 mA/cm2 at a 0.05 mg/cm2 loading when compared to 307 mA/cm2 for the untreated MEA. The impedance of the MEA was determined by ac impedance spectroscopy. The diameter of the arc at low frequency was decreased by increasing the Nafion loading. The optimum Nafion loading value was 0.05 mg/cm2. The cell performance was dependent on the mass-transfer resistance was caused by the methanol chemisorption.Keywords
This publication has 8 references indexed in Scilit:
- Effect of the catalytic ink preparation method on the performance of polymer electrolyte membrane fuel cellsJournal of Power Sources, 2002
- Effect of CO gas and anode-metal loading on H2 oxidation in proton exchange membrane fuel cellJournal of Power Sources, 2001
- Influence of Ionomer Content in Catalyst Layers on Direct Methanol Fuel Cell PerformanceJournal of the Electrochemical Society, 1999
- Influence of Nafion loading in the catalyst layer of gas-diffusion electrodes for PEFCJournal of Power Sources, 1999
- Improved Preparation Process of Very‐Low‐Platinum‐Loading Electrodes for Polymer Electrolyte Fuel CellsJournal of the Electrochemical Society, 1998
- Characterization of direct methanol fuel cells by ac impedance spectroscopyJournal of Power Sources, 1998
- Performance of a direct methanol fuel cellJournal of Applied Electrochemistry, 1998
- High Performance Direct Methanol Polymer Electrolyte Fuel CellsJournal of the Electrochemical Society, 1996