Effect of Chemical Polishing on the Formation of TiO2 Nanotube Arrays Using Ti Mesh as a Raw Material
Open Access
- 26 November 2024
- journal article
- research article
- Published by MDPI AG in Nanomaterials
- Vol. 14 (23) , 1893
Abstract
As a unique form of TiO2, TiO2 nanotube arrays (TiO2NTAs) have been widely used. TiO2NTAs are usually prepared by Ti foil, with little research reporting its preparation by Ti mesh. In this paper, TiO2NTAs are prepared on a Ti mesh surface via an anodic oxidation method in the F-containing electrolyte. The optimal parameters for the synthesis of TiO2NTAs are as follows: the solvent is ethylene glycol and water; the electrolyte is NH4F (0.175 mol/L); the voltage is 20 V; and the anodic oxidation time is 40 min without chemical polishing. However, there is a strange phenomenon where the nanotube arrays grow only at the intersection of Ti wires, which may be caused by chemical polishing, and the other areas, where TiO2NTAs cannot be observed on the surface of Ti mesh, are covered by a dense TiO2 film. New impurities (the hydrate of TiO2 or other products) introduced by chemical polishing and attaching to the surface of the Ti mesh reduce the current of anodic oxidation and further inhibit the growth of TiO2 nanotubes. Hence, under laboratory conditions, for commercially well-preserved Ti mesh, there is no necessity for chemical polishing. The formation of TiO2NTAs includes growth and crystallization processes. For the growth process, F− ions corrode the dense TiO2 film on the surface of Ti mesh to form soluble complexes ([TiF6]2−), and the tiny pores remain on the surface of Ti mesh. Given the basic photoelectrochemical measurements, TiO2NTAs without chemical polishing have better properties.Keywords
Funding Information
- Natural Science Foundation of Shandong Province (ZR2022QB237, ZR2021QB216)
This publication has 62 references indexed in Scilit:
- Ag-TiO2 nanotube arrays prepared by electrochemical deposition with high photocatalytic hydrogen evolution efficiencyJournal of Nanoparticle Research, 2024
- Electrochemical Deposition of Pt and Pd on TiO2 Nanotubes for Application in the Photoelectrocatalytic Conversion of Biomethane and Biogas for Hydrogen GenerationElectrocatalysis, 2023
- Heterogenization of water-soluble porphyrins in Ti/TiO2 nanotubes electrodes: experimental and theoretical insights for atrazine degradationResearch on Chemical Intermediates, 2023
- Investigation of the aging effect of electrolyte on the morphology and photocatalytic properties of TiO2NTs synthesized using the anodization routeJournal of Materials Science, 2021
- A critical review on the variations in anodization parameters toward microstructural formation of TiO2 nanotubesElectrochemical Science Advances, 2021
- Polyoxometalate‐Based Compounds for Photo‐ and Electrocatalytic ApplicationsAngewandte Chemie International Edition, 2020
- Rational Construction of MnCo2O4.5 Deposited TiO2 Nanotube Array Heterostructures with Enhanced Photocatalytic Degradation of TetracyclineChemPhotoChem, 2020
- Preparation of titanium dioxide nanotube arrays on titanium mesh by anodization in (NH4)2SO4/NH4F electrolyteMaterials and Corrosion, 2012
- TiO2 Nanotubes: Synthesis and ApplicationsAngewandte Chemie International Edition, 2011
- Annealing effects on the photoresponse of TiO2 nanotubesPhysica Status Solidi (a), 2006