Comparison of surface seismic sources at the CO2SINK site, Ketzin, Germany
- 5 December 2008
- journal article
- research article
- Published by Wiley in Geophysical Prospecting
- Vol. 57 (1) , 125-139
Abstract
In 2004 three seismic surface sources (VIBSIST, accelerated weight drop and MiniVib) were tested in a pilot study at the Ketzin test site, Germany, a study site for geological storage of CO2 (EU project CO2SINK). The main objectives of this pilot study were to 1) evaluate the response of the Ketzin site to reflection seismics, especially at the planned injection depth, 2) test different acquisition parameters and 3) use the results to guide the planning of the 3D survey. As part of these objectives, we emphasize the source performance comparison in this study. The sources were tested along two perpendicular lines of 2.4 km length each. Data were acquired by shooting at all stations (source and receiver spacing of 20 m) on both lines, allowing common‐midpoint stacked sections to be produced. The sources' signal characteristics based on signal‐to‐noise ratio, signal penetration and frequency content of raw shot records were analysed and stacked sections were compared. The results show that all three surface sources are suitable for reflection seismic studies down to a depth of about 1 km and provide enough bandwidth for resolving the geological targets at the site, i.e., the Weser and Stuttgart Formations. Near surface conditions, especially a thick weathering layer present in this particular area, strongly influence the data quality, as indicated by the difference in reflectivity and signal‐to‐noise ratio of the two common‐midpoint lines. The stacked sections of the MiniVib source show the highest frequency signals down to about 500 ms traveltime (approximately 500 m depth) but also the shallowest signal penetration depth. The VIBSIST source generates signals with the highest signal‐to‐noise ratio and greatest signal penetration depth of the tested sources. In particular, reflections below 900 ms (approximately 1 km depth) are best imaged by the VIBSIST source. The weight drop performance lies in between these two sources and might be recommended as an appropriate source for a 3D survey at this site because of the shorter production time compared to the VIBSIST and MiniVib sources.Keywords
This publication has 26 references indexed in Scilit:
- Baseline characterization of the CO2SINK geological storage site at Ketzin, GermanyEnvironmental Geosciences, 2006
- Monitoring of CO2 injected at Sleipner using time-lapse seismic dataEnergy, 2004
- A comparison between airguns and explosives as wide‐angle seismic sourcesGeophysical Prospecting, 1999
- Seismic lower crustal reflectivity and signal penetration in the Siljan Ring area, Central SwedenTectonophysics, 1998
- Seismic sources for shallow investigations: A field comparison from Northern GermanyJournal of Applied Geophysics, 1998
- Seismic reflection techniques for base metal exploration in eastern Canada: examples from Buchans, NewfoundlandJournal of Applied Geophysics, 1994
- Moho reflectivity and seismic signal penetrationTectonophysics, 1994
- Contributions to a shallow aquifer study by reprocessed seismic sections from petroleum exploration surveys, eastern Abu Dhabi, United Arab EmiratesJournal of Applied Geophysics, 1994
- MINI‐SOSIE FOR LAND SEISMOLOGY*Geophysical Prospecting, 1976
- FACTORS AFFECTING SEISMIC AMPLITUDES*Geophysical Prospecting, 1975