Compact Butler Matrix Using Lumped Elements
- 6 June 2025
- journal article
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 67 (6)
Abstract
This paper describes the design of a new compact circuit for Butler Matrix using few lumped elements to operate at 2.4 GHz. It is demonstrated that acceptable performance could be only achieved by proper electromagnetic modeling of the lumped components using metallic pads and resistor, inductor, and/or capacitor surfaces in Ansys HFSS, to allow compensating for parasitic and coupling effects. The input selection of the proposed architecture is realized digitally using an absorptive switch. The designed circuit has been used to feed a microstrip antenna array to demonstrate the beam switching capability. Very good agreement between the expected and measured results has been verified.Keywords
This publication has 21 references indexed in Scilit:
- A Low-Cost Four-Directional Beamforming Switched Butler Matrix Network Antenna for 5G NR ApplicationsIEEE Access, 2024
- A novel design of compact broadband 4 × 4 Butler matrix-based beamforming antenna array for C-Band applicationsAEU - International Journal of Electronics and Communications, 2021
- Butler Matrix Based Beamforming Networks for Phased Array Antenna Systems: A Comprehensive Review and Future Directions for 5G ApplicationsIEEE Access, 2020
- A compact Butler matrix for wireless power transfer to aid electromagnetic energy harvesting for sensors2017
- Modelling and Validation of a Compact Planar Butler Matrix by Removing CrossoverWireless Personal Communications, 2017
- Ultra‐compact lumped element cross‐overElectronics Letters, 2015
- A switched‐beam microstrip antenna array with miniaturized butler matrix networkMicrowave and Optical Technology Letters, 2015
- Novel wideband multilayer Butler matrix using CPW technology2012
- Compact Butler matrix using composite right/left handed transmission lineElectronics Letters, 2011
- Compact Butler Matrix using size reduced elementsMicrowave and Optical Technology Letters, 2007