Rapid Assembly of Multifunctional Thin Film Sensors for Wind Turbine Blade Monitoring
Authors:
- 31 July 2013
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 569-570, 515-522
Abstract
Wind is a competitive, clean, and fast-growing renewable energy industry. However, in order for wind to compete with fossil fuel-based energies, it is necessary to achieve lower cost of energy. One way is to reduce operations and maintenance costs by integrating structural health monitoring (SHM) systems with wind turbines. It has been found that the fiber-reinforced polymer (FRP) composite-based wind blades are susceptible to damage (e.g., cracks, debonding, and impact). Damage is typically invisible to the naked eye and can propagate rapidly to cause sudden failure. This work presents a new SHM approach using embedded thin film sensors for detecting damage in FRP-based wind blades. While previous studies have shown that carbon nanotube-based thin films can be incorporated with FRPs for sensing, this study further investigates their electromechanical properties. First, a unique spray fabrication approach was employed so that films can be assembled on a low cost basis and can be deposited onto any substrate or structure. Second, the electrical properties of films subjected to post-fabrication thermal annealing were compared. Finally, freestanding films were prepared and subjected to uniaxial tensile cyclic loading while their resistivity was measured simultaneously. The results showed that these films were piezoresistive.Keywords
This publication has 14 references indexed in Scilit:
- The electrical response of carbon nanotube-based thin film sensors subjected to mechanical and environmental effectsSmart Materials and Structures, 2012
- Materials of large wind turbine blades: recent results in testing and modelingWind Energy, 2011
- In situ strain monitoring of fiber-reinforced polymers using embedded piezoresistive nanocompositesJournal of Materials Science, 2010
- Reliability of wind turbine subassembliesIET Renewable Power Generation, 2009
- Carbon Nanotube Sensing Skins for Spatial Strain and Impact Damage IdentificationJournal of Nondestructive Evaluation, 2009
- Structural health monitoring for a wind turbine system: a review of damage detection methodsMeasurement Science and Technology, 2008
- Towards Solutions of Single‐Walled Carbon Nanotubes in Common SolventsAdvanced Materials, 2008
- Multifunctional layer-by-layer carbon nanotube–polyelectrolyte thin films for strain and corrosion sensingSmart Materials and Structures, 2007
- Individually Suspended Single-Walled Carbon Nanotubes in Various SurfactantsNano Letters, 2003
- Structural impedance based damage diagnosis by piezo‐transducersEarthquake Engineering & Structural Dynamics, 2003