Septum polarizer design for antenna feeds produced by casting
Authors:
- S. AmariSAS. Amari
- 22 November 2002
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2, 1422-1425
Abstract
Many septum polarizer components are manufactured by casting. A parameter inherent to this production process is the draft angle, which leads to a linear reduction of housing dimensions with component length and which has been neglected in many polarizer designs over the years. With 25 dB return-loss/isolation and 0.5 dB axial-ratio specifications, however, the draft angle can no longer be neglected, since a slight increase in, e.g., septum thickness can already result in a considerable performance degradation. Therefore, this paper takes the casting manufacturing process fully into account. Moreover, matching transformers are incorporated under the same restrictions.Keywords
This publication has 8 references indexed in Scilit:
- Field theory design of a corrugated septum OMT2002
- Optimum field theory design of stepped E-plane finned waveguide transformers of different inner cross-sections2002
- Ridge waveguide polarizer with finite and stepped-thickness septumIEEE Transactions on Microwave Theory and Techniques, 1995
- Field theory CAD of septum OMT-polarizers1992
- Compact duplexer-polarizer with semicircular waveguide (antenna feed)IEEE Transactions on Antennas and Propagation, 1991
- Analysis of stepped septum polarisersElectronics Letters, 1985
- A Compact Septum PolarizerIEEE Transactions on Microwave Theory and Techniques, 1983
- A wide-band square-waveguide array polarizerIEEE Transactions on Antennas and Propagation, 1973