Microfabricated small metal cantilevers with silicon tip for atomic force microscopy
Authors:
- M.B. VianiMVM.B. Viani
- T.E. SchafferTST.E. Schaffer
- P.K. HansmaPHP.K. Hansma
- 1 March 2000
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 9 (1) , 112-116
Abstract
Atomic force microscopy with small cantilevers is faster due to higher resonant frequencies and has a lower noise level. We report a new process to microfabricate small metal cantilevers with integrated silicon tips. This process is used to fabricate gold cantilevers that are 13-40-/spl mu/m long, 5-10-/spl mu/m wide, and 100-160-nm thick. The tip is first formed at the free end of a sacrificial oxide cantilever. The cantilever layer of the desired metal is then deposited on the nontip side of the sacrificial oxide cantilever. The oxide layer is removed to form the cantilevers with tips on them in a batch process. The highly stressed cantilevers are rapid thermal annealed for 60 s at 300/spl deg/C to relieve the stress. The gold cantilevers have been characterized through their thermal spectra and used to image in tapping mode. The process can be used, not only for gold, but also for any metal or compound that can withstand removal of sacrificial oxide cantilevers.Keywords
This publication has 17 references indexed in Scilit:
- Fast imaging and fast force spectroscopy of single biopolymers with a new atomic force microscope designed for small cantileversReview of Scientific Instruments, 1999
- Small cantilevers for force spectroscopy of single moleculesJournal of Applied Physics, 1999
- Characterization and optimization of the detection sensitivity of an atomic force microscope for small cantileversJournal of Applied Physics, 1998
- New technique for nanocantilever fabrication based on local electrochemical etching: Applications to scanning force microscopyJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 1997
- Atomic force microscope for small cantilevers1997
- Fabrication of an all-metal atomic force microscope probe1997
- Method for the calibration of atomic force microscope cantileversReview of Scientific Instruments, 1995
- Silicon sensors with integral tips for atomic force microscopy: a novel single-mask fabrication processJournal of Micromechanics and Microengineering, 1993
- A nondestructive method for determining the spring constant of cantilevers for scanning force microscopyReview of Scientific Instruments, 1993
- Oxidation sharpening of silicon tipsJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 1991