Statistical Analysis of Cutting Forces in Turning Inconel 718 with Coated Carbide Tools
Authors:
- 1 October 2010
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 135, 96-101
Abstract
The experimental study presented in this paper aims to investigate the effects of cutting parameters on cutting forces, and search the optimal cutting parameters for the minimum cutting forces during turning Inconel 718 under dry cutting conditions. Based on Taguchi method, a L25 (53) array was designed to conduct the turning experiments. The experimental results indicate that the best condition for the minimum cutting force components is the combination of 45m/min cutting speed, 0.08mm/r feed rate, and 0.2mm depth of cut. The effects of the cutting parameters on cutting forces are investigated while employing the analysis of variance (ANOVA). Finally, the quadratic regression equations for cutting forces were formulated, which can well describe the relationship between cutting parameters and cutting forces.Keywords
This publication has 7 references indexed in Scilit:
- Experimental investigations of cutting parameters influence on cutting forces and surface roughness in finish hard turning of MDN250 steelJournal of Materials Processing Technology, 2008
- Modelling tool wear in cemented-carbide machining alloy 718International Journal of Machine Tools and Manufacture, 2008
- An investigation of cutting forces and surface damage in high-speed turning of Inconel 718Journal of Materials Processing Technology, 2007
- The effect of cutting speed and cutting tool geometry on machinability properties of nickel-base Inconel 718 super alloysMaterials & Design (1980-2015), 2007
- On machining of hardened AISI D2 steel with PCBN toolsJournal of Materials Processing Technology, 2006
- Effects of cutting edge geometry, workpiece hardness, feed rate and cutting speed on surface roughness and forces in finish turning of hardened AISI H13 steelThe International Journal of Advanced Manufacturing Technology, 2004
- Temperature and wear of cutting tools in high-speed machining of Inconel 718 and Ti6Al6V2SnWear, 1997