In Situ Study of Molecular Doping of Chlorine on MoS2 Field Effect Transistor Device in Ultrahigh Vacuum Conditions
Authors:
Open Access
- 22 October 2020
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 5 (43) , 28108-28115
Abstract
We report a precise measurement of the sensor behavior of the field effect transistor (FET) formed with the MoS2 channel when the channel part is exposed to Cl2 gas. The gas exposure and the electrical measurement of the MoS2 FET were executed with in situ ultrahigh-vacuum (UHV) conditions in which the surface analysis techniques were equipped. This makes it possible to detect how much sensitivity the MoS2 FET can provide and understand the surface properties. With the Cl2 gas exposure to the channel, the plot of the drain current versus the gate voltage (Id–Vg curve) shifts monotonically toward the positive direction of Vg, suggesting that the adsorbate acts as an electron acceptor. The Id–Vg shifts are numerically estimated by measuring the onset of Id (threshold voltage, Vth) and the mobility as a function of the dosing amounts of the Cl2 gas. The behaviors of both the Vth shift and the mobility with the Cl2 dosing amount can be fitted with the Langmuir adsorption kinetics, which is typically seen in the uptake curve of molecule adsorption onto well-defined surfaces. This can be accounted for by a model where an impinging molecule occupies an empty site with a certain probability, and each adsorbate receives a certain amount of negative charge from the MoS2 surface up to the monolayer coverage. The charge transfer makes the Vth shifts. In addition, the mobility is reduced by the enhancement of the Coulomb scattering for the electron flow in the MoS2 channel by the accumulated charge. From the thermal desorption spectroscopy (TDS) measurement and density functional theory (DFT) calculations, we concluded that the adsorbate that is responsible for the change of the FET property is the Cl atom that is dissociated from the Cl2 molecule. The monotonic shift of Vth with the coverage suggests that the MoS2 device sensor has a good sensitivity to detect 10–3 monolayers (ML) of adsorption corresponding to the ppb level sensor with an activation time of 1 s.Keywords
Funding Information
- Japan Society for the Promotion of Science (15K13506, 16H06353, 18H04482, 19H05621)
- World Premier International Research Center Initiative
This publication has 42 references indexed in Scilit:
- Flexible MoS2 sensor arrays for high performance label-free ion sensingSensors and Actuators A: Physical, 2019
- Illumination impact on monolayer MoS2 chemical sensor arraysSensors and Actuators A: Physical, 2018
- Towards intrinsic MoS2 devices for high performance arsenite sensingApplied Physics Letters, 2016
- Air-Stable Surface Charge Transfer Doping of MoS2 by Benzyl ViologenJournal of the American Chemical Society, 2014
- Density functional theory study of chemical sensing on surfaces of single-layer MoS2 and grapheneJournal of Applied Physics, 2014
- High-Performance Chemical Sensing Using Schottky-Contacted Chemical Vapor Deposition Grown Monolayer MoS2 TransistorsACS Nano, 2014
- Molecular Doping of Multilayer ${\rm MoS}_{2}$ Field-Effect Transistors: Reduction in Sheet and Contact ResistancesIEEE Electron Device Letters, 2013
- Fabrication of Flexible MoS2 Thin‐Film Transistor Arrays for Practical Gas‐Sensing ApplicationsSmall, 2012
- Atomically Thin: A New Direct-Gap SemiconductorPhysical Review Letters, 2010
- Two-dimensional atomic crystalsProceedings of the National Academy of Sciences, 2005