Electrochemical and corrosion behaviors of nickel and Ni-Cr alloys in molten Na2SO4, NaCl and their mixtures at 1, 173K under air were examined by the measurements of polarization curves and corrosion loss after immersion test. Particular attention was given to influence of salt composition and chromium addition to nickel. Cathodic polarization curves in the vicinity of corrosion potential of nickel exhibited current peaks corresponding to the cathodic reduction of NiO formed during immersion, whereas those of Ni-Cr alloys exhibited the limiting current densities corresponding to catholic reductions of SO3 generated by the dissociation of sulfate ion and O2 dissolved into molten salt from air. The values of limiting current densities for Ni-Cr alloys in the molten mixtures increased with increasing concentration of NaCl because of an increase in the rate of cathodic reduction of dissolved O2. Anodic polarization curves of nickel and Ni-Cr alloys also varied with the concentration of NaCl. The active-passive transition observed for nickel became indistinct and the self-passivation behavior observed for Ni-5Cr alloy was slightly inhibited with increasing the concentration of NaCl, respectively. The anodic polarization curves of Ni-20Cr alloy in molten mixtures exhibited a passivation behavior even if a large amount of chloride was added, but that of Ni-20Cr alloy in molten NaCl exhibited an active dissolution behavior. Corrosion losses of nickel after the immersion test in molten Na2SO4 and mixtures were large. On the contrary, corrosion losses of Ni-Cr alloys in their melts were extremely small. A difference in corrosion loss between nickel and Ni-Cr alloys in molten NaCl was scarcely observed. These results could be explained by partial polarization curves presumed from the electrochemical results.