Energy Efficient Heat Sink Design: Natural Versus Forced Convection Cooling
Authors:
- Daniel ChristenDCDaniel Christen
- Milos StojadinovicMSMilos Stojadinovic
- Juergen BielaJBJuergen Biela
- 15 December 2016
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 32 (11) , 8693-8704
Abstract
In highly efficient converter systems the power consumption of the cooling system (fans) significantly influences the total system efficiency as well as the power density. This paper investigates the potential of free convection cooled heat sinks and compares their performance to forced convection cooled heat sinks on the basis of their volume and power consumption. Underlying theoretical concepts for both types of cooling systems are summarized and their application in an optimization procedure is presented. The theoretical concepts are validated with prototype heat sinks. Finally, at an example of a half-bridge converter it is shown that by free convection cooling not only the efficiency but also the power density can be increased. In this case by paralleling semiconductor devices the losses decrease approximately by a factor of three while simultaneously the heat sink volume can be reduced by approximately 50%.Keywords
This publication has 21 references indexed in Scilit:
- Generalized Models for Laminar Developing Flows in Heat Sinks and Heat ExchangersHeat Transfer Engineering, 2013
- Comparison of a soft switched TCM T-Type inverter to hard switched inverters for a 3 phase PV grid interface2012
- General correlation of a natural convective heat sink with plate-fins for high concentrating photovoltaic module coolingSolar Energy, 2012
- Optimization of forced convection heat sinks with pumping power requirementsInternational Journal of Heat and Mass Transfer, 2011
- Fundamental Performance Limits of HeatsinksJournal of Electronic Packaging, 2003
- Design of Optimum Plate-Fin Natural Convective Heat SinksJournal of Electronic Packaging, 2003
- Optimization of parallel plate heatsinks for forced convection2002
- Thermally Optimum Spacing of Vertical, Natural Convection Cooled, Parallel PlatesJournal of Heat Transfer, 1984
- Free Convection Nusselt Number for Vertical U-Shaped ChannelsJournal of Heat Transfer, 1973
- Free Convection Heat Transfer Coefficients From Rectangular Vertical FinsJournal of Heat Transfer, 1965