Influence of n-octanol and α-terpineol on thin film stability and bubble attachment to hydrophobic surface
- 12 December 2012
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 15 (7) , 2586-2595
Abstract
We have investigated the influence of concentration of surfactants typically used as flotation frothers (α-terpineol and n-octanol) and roughness of the solid surface on phenomena occurring during rising bubble collisions with a model hydrophobic Teflon surface. The time of three-phase contact (TPC) formation (tTPC) and the time of drainage (tD) of the film formed between the colliding bubble and Teflon surfaces were determined using a high-speed camera working with a frequency 1040 Hz. The Teflon surface roughness was varied on a microscopic scale, within a roughness ranging between 1 and 100 μm. We have found that the roughness of the Teflon surface is a crucial factor of the kinetics of the TPC formation, both in the absence and in the presence of the surfactants. With the surface roughness increasing from ca. 1 to 80 μm the tTPC can be shortened by an order of magnitude, i.e. from 105 ms down to a few milliseconds. We have demonstrated that bouncing of the colliding bubble is responsible for the large differences in the times of TPC formation at the Teflon surfaces of different roughness. Low concentrations of α-terpineol and n-octanol caused a decrease in the tTPC with respect to distilled water. However, at high concentrations the tTPC was prolonged. The prolongation of the time of the TPC formation was dependent on the Teflon surface roughness and we have attributed this effect to different amounts of air present in the cavities and scratches of hydrophobic surfaces of different roughness. The mechanism of prolongation of the tTPC at high concentration of surface-active substances (frother overdosage) is proposed.Keywords
This publication has 30 references indexed in Scilit:
- A review of induction and attachment times of wetting thin films between air bubbles and particles and its relevance in the separation of particles by flotationAdvances in Colloid and Interface Science, 2010
- Fundamental properties of flotation frothers and their effect on flotationMinerals Engineering, 2006
- Coal reverse flotation. Part I: Separation of a mixture of subbituminous coal and gangue mineralsMinerals Engineering, 2006
- Effect of frothers on bubble sizeInternational Journal of Mineral Processing, 2005
- Bubble coalescence and its effect on dynamic foam stabilityThe Canadian Journal of Chemical Engineering, 2002
- Effect of flotation frothers on bubble size and foam stabilityInternational Journal of Mineral Processing, 2002
- The interaction between particles and bubblesColloids and Surfaces A: Physicochemical and Engineering Aspects, 1999
- Elementary steps in particle—bubble attachmentInternational Journal of Mineral Processing, 1997
- Wet foams: Formation, properties and mechanism of stabilityAdvances in Colloid and Interface Science, 1992
- Thin liquid filmsAdvances in Colloid and Interface Science, 1967