Flexure Strength, Fracture Toughness, and Slow Crack Growth of YSZ/Alumina Composites at High Temperatures
Authors:
- 27 April 2005
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 88 (6) , 1474-1480
Abstract
Flexure strength and fracture toughness of zirconia–alumina composites, fabricated by hot pressing 10 mol% yttria‐stabilized zirconia (10‐YSZ) reinforced with 0–30 mol% alumina particulates or platelets, were determined as a function of alumina content at 1000°C in air. Both strength and fracture toughness of the two composite systems increased with increasing alumina content. For a given alumina content, flexure strength of the particulate composites was greater than that of the platelet composites at higher alumina contents (≥20 mol%); whereas, fracture toughness of the platelet composites was greater than that of the particulate counterparts, regardless of the alumina content. The susceptibility to slow crack growth (SCG), determined at 1000°C via constant stress‐rate testing, was greatest for 30 mol% particulate composite with SCG parameter n =5–8 and was least for 30 mol% platelet composite with n =33. Elastic modulus of both composite systems decreased below 400°C and then remained almost unchanged up to 1000°C, forming a unique transition around 400°C, irrespective of alumina content.Keywords
This publication has 25 references indexed in Scilit:
- Mechanical behavior of zirconia/alumina compositesCeramics International, 2005
- Specimem Geometry Effect on the Determination of Slow Crack Growth Parameters of Advanced Ceramics in Constant Flexural Stress-Rate Testing at Elevated Temperatures1999
- Toughening of ionic conductive zirconia ceramics utilizing a non-linear effectSolid State Ionics, 1996
- Time-Dependent Reliability Analysis of Monolithic Ceramic Components Using the Cares/Life Integrated Design Program1994
- A comparison of failure predictions by dynamic bending and cyclic bending fatigue techniques for Y2O3ZrO2 ceramicsInternational Journal of Fatigue, 1993
- Crack Resistance and Fatigue of Transforming Ceramics: I, Materials in the ZrO 2 –Y 2 O 3 –Al 2 O 3 SystemJournal of the American Ceramic Society, 1991
- Temperature Dependence of Young's Modulus and Internal Friction in Alumina, Silicon Nitride, and Partially Stabilized Zirconia CeramicsJournal of the American Ceramic Society, 1984
- High‐Temperature Fatigue Behavior of Polycrystalline AluminaJournal of the American Ceramic Society, 1980
- Crystallization of grain boundary phases in hot-pressed silicon nitride materialsJournal of Materials Science, 1978
- Side-Cracked Plates Subject to Combined Direct and Bending Forces1976