Experimental and Modeling Study of Peanut Drying in a Solar Dryer with a Novel Type of a Drying Chamber
- 14 September 2021
- journal article
- research article
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 44 (2) , 5586-5609
Abstract
The aim of the present study is to investigate the experimental performance of a solar dryer by using a novel type of a drying chamber for increasing the drying performance and ensuring homogeneous drying. The drying system (SDS) consisted of a new type of a drying chamber and a solar air collector, which were designed, made, and tested in Osmaniye, Turkey. The analyses of Computational Fluid Dynamics were carried out to demonstrate the advantage of the designed drying chamber over the tunnel type drying chamber, which is commonly used in peanut drying. The drying experiments were conducted using in-shell peanut to observe the performance of the system. The drying procedure was performed in the form of open sun drying (OSD), and the results of drying kinetics such as moisture ratio (MR), drying rate (DR), and heat transfer coefficient (hc) obtained from both drying methods were compared. The MR and DR values obtained during the drying experiments were estimated using different models such as mathematical, multiple linear regression (MLR), decision tree (DT), and the support vector machine (SVM). It was observed from the numerical results that the products can dry more homogenously and effectively with the newly designed drying chamber compared to the conventional tunnel type drying chamber. The results of the drying experiments showed that the products dried earlier and more regularly through the SDS compared to the OSD. The DR and hc values were found 0.0051E-01 (gw/gdm)/min and 1.5727 W/m2°C for SDS and 0.0039E-01 (gw/gdm)/min and 1.4664 W/m2°C for OSD, respectively. The models that best estimated the experimentally obtained MR and DR values for peanuts dried with the SDS proved to be the Random Tree Model (R2 = 0.9972) and Quintic Model (R2 = 0.8551), respectively.Keywords
Funding Information
- Osmaniye Korkut Ata University, Scientific Research Projects Unit (OKUBAP-2014-PT3-032)
This publication has 45 references indexed in Scilit:
- Modeling using a new thin layer drying model and product quality of cocoaJournal of Food Engineering, 2009
- Drying of red pepper in open sun and greenhouse conditions.Journal of Food Engineering, 2007
- Effect of mass on convective mass transfer coefficient during open sun and greenhouse drying of onion flakesJournal of Food Engineering, 2007
- EXPERIMENTAL DETERMINATION OF CONVECTIVE HEAT TRANSFER COEFFICIENT OF SOME AGRICULTURAL PRODUCTS IN FORCED CONVECTION DRYINGInternational Communications in Heat and Mass Transfer, 2004
- An assessment of the effectiveness of decision tree methods for land cover classificationRemote Sensing of Environment, 2003
- Mathematical modelling of solar drying of apricots in thin layersJournal of Food Engineering, 2002
- A NEW MODEL FOR SINGLE-LAYER DRYINGDrying Technology, 2002
- Convective heat transfer coefficient of crops in forced convection drying – an experimental studyEnergy Conversion and Management, 2001
- Evaluation of convective heat transfer coefficient in crop drying under open sun drying conditionsEnergy Conversion and Management, 2001
- Exposed-layer barley drying: Three models fitted to new data up to 150°CJournal of Agricultural Engineering Research, 1985