Two-Way Shape Memory Effect in Rapidly-Quenched High-Copper TiNiCu Alloys Deformed in the Martensitic State
- 1 April 2020
- journal article
- research article
- Published by Pleiades Publishing Ltd in Russian Metallurgy (Metally)
- Vol. 2020 (4) , 345-350
Abstract
The effect of martensitic deformation on the two-way shape-memory effect (SME) of quasi-binary high-copper TiNi–TiCu alloys (with 25–40 at % Cu) is studied. The alloys are prepared by rapid quenching from the melt in an amorphous state in the form of ribbons 30–50 μm in thickness. The alloys crystallize during isothermal annealing, the time of which is varied from 100 to 300 s, and during a single current pulse 10 ms in duration. The relatively low bending strains (1.5–3%) are shown to cause two-way SME in TiNiCu alloys; as the strain of martensite increases, the reversible strain in the martensitic transformation range increases markedly. An increase in the copper content is found to cause a substantial decrease in the value of two-way SME, which is related to the formation of the brittle TiCu phase. At the same time, a decrease in the heat treatment time causes an increase in the reversible strain, which reaches the maximum value (2.35%) for the alloy with 25 at % Cu subjected to high-rate electric pulse treatment.Keywords
This publication has 13 references indexed in Scilit:
- A review of shape memory alloy research, applications and opportunitiesMaterials & Design (1980-2015), 2014
- Study of Two-Way Shape Memory Behavior of Amorphous-Crystalline TiNiCu Melt-Spun RibbonsMaterials Science Forum, 2013
- Crystallization Behavior of Ti-(50-x)Ni-xCu(at%) (x = 20-30) Alloy RibbonsTransactions on Electrical and Electronic Materials, 2011
- Microstructures and shape memory characteristics of a Ti–20Ni–30Cu (at.%) alloy strip fabricated by the melt overflow processScripta Materialia, 2010
- Thermomechanical training and the shape recovery characteristics of NiTi alloysMaterials Science and Engineering: A, 2008
- Role of external applied stress on the two-way shape memory effectMaterials Science and Engineering: A, 2006
- Physical metallurgy of Ti–Ni-based shape memory alloysProgress in Materials Science, 2005
- Two-way shape memory effect of NiTi alloy induced by constraint aging treatment at room temperatureMetallurgical and Materials Transactions A, 2001
- Shape memory properties of the Ti36Ni49Hf15 high temperature shape memory alloyMaterials Letters, 2000
- The two way shape memory effect of shape memory alloys: an experimental study and a phenomenological modelInternational Journal of Plasticity, 2000