Study on the influence of pore dip angle on acoustic emission characteristics of sandstone with composite defects
Authors:
Open Access
- 25 November 2025
- journal article
- cell biology
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 20 (11) , e0337723
Abstract
Rock defects are a key internal factor leading to deformation and failure under load. This study investigates red sandstone specimens with combined pore–fracture defects at different pore dip angles through uniaxial compression tests, while employing Acoustic Emission monitoring to capture the failure process. The evolution of AE characteristic parameters and rock failure modes is analyzed. The results indicate that: (1) the presence of pores prolongs both the time to failure and the onset of the AE burst stage, with longer durations observed at higher pore dip angles; (2) AE signal amplitude and frequency vary significantly across different loading stages, and the b-value exhibits an “increase–fluctuation–decrease” trend, with the decreasing stage serving as a precursor to rock instability; (3) pore dip angle strongly influences crack propagation types: dip angles of 0°–30° favor axial cracks and through-going wing cracks, 45°–75° angles tend to induce co-planar and wing crack connectivity, while 90° angles cause crack deviation, hindering through-going failure; (4) intact rock fails in a tensile–shear mixed mode, whereas the number of shear cracks in rocks with pores initially increases and then decreases with dip angle, reaching a maximum at 45°, resulting in shear-dominated failure. These findings reveal the failure characteristics and AE evolution patterns of rocks with combined pore–fracture defects at different pore dip angles, providing insights for the identification of precursors to rock failure and for disaster prevention and mitigation.Keywords
Funding Information
- the National Key R&d projects (2017YFC1503101)
- the General Programs of Liaoning Natural Science Foundation (LJ2020JCL013)
- General Research Project of the Liaoning Provincial Department of Education (LJ212510147044)
This publication has 28 references indexed in Scilit:
- Evolution of strain field and acoustic emission characteristics at ECC and coal gangue concrete shear interfaceJournal of Building Engineering, 2025
- Investigation of mechanical behavior, AE and EMR characteristics of rocks under compression-shear loading via variable-angle shear testsJournal of Applied Geophysics, 2023
- Deformation behaviour, crack initiation and crack damage of weathered composite sandstone-shale by using the ultrasonic wave and the acoustic emission under uniaxial compressive stressInternational Journal of Rock Mechanics and Mining Sciences, 2023
- Master crack types and typical acoustic emission characteristics during rock failureInternational Journal of Coal Science & Technology, 2023
- Influence of rock bridge length on geomechanical behaviors of granite containing a hole and fissures under uniaxial increasing-amplitude decreasing-frequency cyclic loadsArabian Journal of Geosciences, 2022
- Developing a new acoustic emission source classification criterion for concrete structures based on signal parametersConstruction and Building Materials, 2022
- Experimental study on acoustic emission (AE) characteristics and crack classification during rock fracture in several basic lab testsInternational Journal of Rock Mechanics and Mining Sciences, 2020
- Fracture behavior and acoustic emission characteristics of sandstone samples with inclined precracksInternational Journal of Coal Science & Technology, 2020
- Investigation on mechanical behavior and crack coalescence of sandstone specimens containing fissure-hole combined flaws under uniaxial compressionGeosciences Journal, 2018
- Optical detection of crack patterns in the opening-mode fracture of marbleInternational Journal of Rock Mechanics and Mining Sciences, 1987