6.5 A 3dB-NF 160MHz-RF-BW Blocker-Tolerant Receiver with Third-Order Filtering for 5G NR Applications
Authors:
- 13 February 2021
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 64, 98-100
Abstract
The introduction of the fifth-generation (5G) New Radio (NR) standard has imposed several challenges in the design of sub-6GHz receivers (RX). Firstly, the maximum channel bandwidth(2BW) increases to 100MHz, while a -15dBm continuous-wave (CW) blocker can be located only $\Delta$ f=85MHz away from the desired band edge. Such a small $\Delta$ f/BW($\sim$2) places a stringent linearity requirement on an RX, thus demanding the use of higher-order filtering. Secondly, in-band (IB) linearity also becomes critical, since the band of interest may contain many signals resulting from carrier aggregation and digital beamforming operation. Finally, a sub-3dB noise Figure (NF) is required to achieve the highest possible link budget, which allows to maximize the spectral efficiency and data rate.
Keywords
This publication has 7 references indexed in Scilit:
- Analysis and Design of a 260-MHz RF Bandwidth +22-dBm OOB-IIP3 Mixer-First Receiver With Third-Order Current-Mode Filtering TIAIEEE Journal of Solid-State Circuits, 2020
- A Quantized Analog RF Front EndIEEE Journal of Solid-State Circuits, 2019
- A Baseband-Matching-Resistor Noise-Canceling Receiver Architecture to Increase In-Band Linearity Achieving 175MHz TIA Bandwidth with a 3-Stage Inverter-Only OpAmp2019
- 28.7 A Wideband Blocker-Tolerant Receiver with High-Q RF-Input Selectivity and <-80dBm LO Leakage2019
- Enhanced-Selectivity High-Linearity Low-Noise Mixer-First Receiver With Complex Pole Pair Due to Capacitive Positive FeedbackIEEE Journal of Solid-State Circuits, 2018
- Channel Selection at RF Using Miller Bandpass FiltersIEEE Journal of Solid-State Circuits, 2014
- A 65 nm CMOS Quad-Band SAW-Less Receiver SoC for GSM/GPRS/EDGEIEEE Journal of Solid-State Circuits, 2011