Interaction Between Circumferential Lamb Waves and Lamination in the Midplane of a Metallic Pipe
- 7 December 2017
- journal article
- research article
- Published by ASME International in Journal of Pressure Vessel Technology
- Vol. 140 (1) , 011406
Abstract
Lamination is one of common defects in the manufacturing process of seamless metallic pipes. In this paper, the interaction between the circumferential Lamb waves and lamination in the midplane of an aluminum pipe is studied. The used circumferential Lamb waves are CL0 and CL1 modes generated with a finite element method code. Lamination along the circumferential direction is established by the demerging-node method. Numerical results of arrival time are compared with theoretical results in order to verify the accuracy of the excitation ways. The interaction between circumferential Lamb waves and lamination in a damaged full circular pipe is analyzed by composing the received waveforms of the corresponding receivers when CL0 and CL1 modes are excited at different excitation positions: the inner subpipe, the outer subpipe, and the main pipe. The composed waveforms fit well with the original waveforms. When CL0/CL1 mode reaches the entrance and exit of a lamination, it generates new mode and undergoes multiple reverberations, diffraction, and mode conversion between the two ends of the lamination. Based on the detailed analysis of the waveform in detail, some phenomena, which are different from those in a plate, are observed.Keywords
Funding Information
- National Natural Science Foundation of China (51475012)
- National Natural Science Foundation of China (and 11272021)
- National Natural Science Foundation of China (11772014)
- National Natural Science Foundation of China (51235001)
- Beijing Municipal Commission of Education (KM201010005003)
This publication has 25 references indexed in Scilit:
- Detection of a radial crack in annular structures using guided circumferential waves and continuous wavelet transformMechanical Systems and Signal Processing, 2012
- Interaction of guided Lamb waves with an asymmetrically located delamination in a laminated composite plateSmart Materials and Structures, 2010
- Tone-Burst Generation of Circumferential Guided Waves by a Bulk Shear Wave Sensor and Their Wide-Range Time–Frequency AnalysesJapanese Journal of Applied Physics, 2008
- Ultrasonic Circumferential Guided Wave for Pitting-Type Corrosion Imaging at Inaccessible Pipe-Support LocationsJournal of Pressure Vessel Technology, 2008
- Circumferential higher order guided wave modes for the detection and sizing of cracks and pinholes in pipe support regionsNDT & E International, 2008
- Best practice for the assessment of defects in pipelines – CorrosionEngineering Failure Analysis, 2007
- Separation of interfering acoustic scattered signals using the invariants of the time-reversal operator. Application to Lamb waves characterizationThe Journal of the Acoustical Society of America, 1998
- Guided Circumferential Waves in a Circular AnnulusJournal of Applied Mechanics, 1998
- Influences of Feed and Cross Angle on Inside Bore and Lamination Defects in Rotary Piercing for Materials with Poor Hot Workability.ISIJ International, 1997
- A two-dimensional Fourier transform method for the measurement of propagating multimode signalsThe Journal of the Acoustical Society of America, 1991