SuperRail–World-First HTS Cable to be Installed on a Railway Network in France
- 26 January 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 34 (3) , 1-7
Abstract
The SuperRail project consists in the development, manufacturing, installation and long-term operation of a high temperature superconducting (HTS) dc cable system for railway applications. The objectives of the project are to reinforce the power supply of the Montparnasse railway station in Paris, to increase the traffic and to participate to the reduction of CO 2 emission. The saturated underground in the center of Paris does not allow to create new right of ways and only the HTS cable technology allows to carry the required power to railway tracks using the few available 100 mm conduits left. The HTS cable system must answer to a load chart with a high level of requirements corresponding to the connection of a substation to a set of railways tracks in very constraints areas. In the case of SuperRail, two 60-meter long 1.5 kV–3.5 kA HTS dc cables made of second-generation (2G) conductors will be installed in parallel. They need to sustain a 67 kA–200 ms short-circuit current. The cryogenic system is specifically designed for this project. It is based on a Reverse Turbo-Brayton cycle producing cooling power of about 1700 W at 67 K. This system intends to ensure low maintenance during life cycle, high reliability and would be scalable for future application (not limited to railways). In parallel, prospective studies are being carried out to simulate superconducting cables in railway networks, and to find original solutions to replace the current leads. SuperRail is a landmark project, as it is the first time that a dc HTS cable system is installed on a commercially operated railway network. The technologies developed have the potential to be reproduced in similar cases existing in large cities.Keywords
Funding Information
- French government via the Banque Publique d'Investissement
- France 2030 plan
This publication has 36 references indexed in Scilit:
- Critical current behavior of a BSCCO tape in the stacked conductors under different current feeding modePhysica C: Superconductivity and its Applications, 2013
- First Russian long length HTS power cablePhysica C: Superconductivity and its Applications, 2012
- Modeling of a 22.9kV 50MVA superconducting power cable based on PSCAD/EMTDC for application to the Icheon substation in KoreaPhysica C: Superconductivity and its Applications, 2011
- DC critical current and AC loss measurement of the 100m 22.9kV/50MVA HTS cablePhysica C: Superconductivity and its Applications, 2008
- Demonstration and Verification Tests of 500 m Long HTS Power CableIEEE Transactions on Applied Superconductivity, 2005
- Development of the 22.9-kV Class HTS Power Cable in LG CableIEEE Transactions on Applied Superconductivity, 2005
- Operation experiences with a 30 kV/100 MVA high temperature superconducting cable systemSuperconductor Science and Technology, 2004
- Electric properties of a 66 kV 3-core superconducting power cable systemIEEE Transactions on Applied Superconductivity, 2003
- Test results of a 30 m high-tc superconducting power cableIEEE Transactions on Applied Superconductivity, 2003
- Qualification results of a 50 m-115 kV warm dielectric cable systemIEEE Transactions on Applied Superconductivity, 2001