Comparison of Material Flow Stress Models toward More Realistic Simulations of Friction Stir Processes of Mg AZ31B
Authors:
- 23 May 2014
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 783-786, 2239-2243
Abstract
Utilizing a proper material model for describing the mechanical behavior of any material is key for a successful simulation of friction stir processing (FSP) where temperature, strain, and strain rate gradients vary abruptly within, and when moving away, from the stirring zone. This work presents a comparison of how faithfully do three different constitutive equations reproduce the state variables of strain, strain rate, and temperature in an FEM simulation of a test-case FSP (1000 rpm spindle speed, and 90 mm/min feed). The three material models considered in this comparison are namely: Johnson-Cook (JC), Sellars-Tegart (ST), and Zerilli-Armstrong (ZA). Constants for these constitutive equations are obtained by fitting these equations to experimental mechanical behavior data collected under a range of strain rates and temperatures of twin-rolled cast wrought AZ31B sheets.It is widely recognized that JC-based models over predicts stress values in the stir zone whereas ST-based models are incapable of capturing work hardening outside of the stir zone. Therefore, a ZA model, being a physical based-HCP specific model, is hereby investigated for its suitability as a material model that would overcome such drawbacks of JC-and ST-based models. The equations from the constitutive models under consideration are fed into an FEM model built using DEFORM 3D to simulate the traverse phases of a friction stir process. Amongst these three material models, comparison results suggest that the HCP-specific ZA model yield better predictions of the state variables: strain, strain rate, and temperature, and, consequently, the estimated values for flow stresses.Keywords
This publication has 10 references indexed in Scilit:
- FEM Optimization of Process Parameters and In-Process Cooling in the Friction Stir Processing of Magnesium Alloy AZ31b2013
- Effects of the Strain Rate and Temperature on the Microstructural Evolution of Twin-Rolled Cast Wrought AZ31B Alloys SheetsJournal of Materials Engineering and Performance, 2013
- Modeling the Effects of Coolant Application in Friction Stir Processing on Material Microstructure Using 3D CFD AnalysisJournal of Materials Engineering and Performance, 2011
- Effect of rotational speed and probe profile on microstructure and hardness of AZ31/Al2O3 nanocomposites fabricated by friction stir processingMaterials & Design (1980-2015), 2011
- Numerical studies on controlling of process parameters in friction stir weldingJournal of Materials Processing Technology, 2009
- Recrystallization mechanisms during friction stir welding/processing of aluminum alloysScripta Materialia, 2008
- Dislocation mechanics-based constitutive equationsMetallurgical and Materials Transactions A, 2004
- Relationship between grain size and Zener–Holloman parameter during friction stir processing in AZ31 Mg alloysScripta Materialia, 2004
- Flow Stress Mtcrostructures and Modeling in Hot Extrusion of Magnesium Alloys2000
- Hot WorkabilityInternational Materials Reviews, 1972