Dynamic behavior of fundamental-mode stabilized VCSELs using a shallow surface relief
Authors:
- 7 June 2004
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Quantum Electronics
- Vol. 40 (6) , 607-619
Abstract
An extensive theoretical study was performed on the dynamic behavior of 850-nm-wavelength oxide-confined fundamental-mode stabilized vertical-cavity surface-emitting lasers (VCSELs), using a shallow surface relief. The surface relief is used to provide lower mirror loss for the fundamental mode, thus acting as a mode discriminator. In this way, single-mode operation at high power levels can be obtained. We utilized a comprehensive model that includes the detailed epitaxial layer structure and device geometry when calculating the optical fields and that accurately accounts for the dynamic effects of carrier density and temperature on the modal distributions. Modulation response, eye diagrams, bit error rate (BER), and relative intensity noise (RIN) were simulated and compared to the performance of VCSELs without a mode discriminator, i.e., conventional multimode VCSELs. The fundamental-mode stabilized VCSELs are associated with a higher out-coupling, which lowers the relaxation oscillation frequency and damping, and strong spatial hole burning, which induces a low-frequency roll-off in the modulation response and contributes to the damping of the relaxation oscillation at low bias. However, their dynamics is fully competitive with conventional multimode VCSELs at both 2.5 and 10 Gb/s although they exhibit a slightly higher eye closure. We only found a 0.5-dB power penalty in the BER. The RIN is enhanced, with a peak that is about 10-15 dB higher, caused by the lower damping of the relaxation oscillation. It should be noted that in the comparison we assume that all modes are equally captured from the multimode VCSEL. A mode-selective loss can severely degrade its performance.Keywords
This publication has 27 references indexed in Scilit:
- Spatially dependent noise model for vertical-cavity surface-emitting lasersIEEE Journal of Quantum Electronics, 2004
- Harmonic and intermodulation distortion in oxide-confined vertical-cavity surface-emitting lasersIEEE Journal of Quantum Electronics, 2003
- Impact of spatial hole burning on modulation response of vertical cavity surface emitting lasers2003
- A comprehensive model for the modal dynamics of vertical-cavity surface-emitting lasersIEEE Journal of Quantum Electronics, 2002
- Transverse mode selection in large-area oxide-confined vertical-cavity surface-emitting lasers using a shallow surface reliefIEEE Photonics Technology Letters, 1999
- Noise characteristics of 850 nm single-mode vertical cavity surface emitting lasersApplied Physics Letters, 1998
- Theoretical analysis of polarization bistability in vertical cavity surface emitting semiconductor lasersJournal of Lightwave Technology, 1997
- Comprehensive numerical modeling of vertical-cavity surface-emitting lasersIEEE Journal of Quantum Electronics, 1996
- A comparative study on the thermal characteristics of vertical-cavity surface-emitting lasersJournal of Applied Physics, 1995
- Calculated spontaneous emission factor for double-heterostructure injection lasers with gain-induced waveguidingIEEE Journal of Quantum Electronics, 1979