Investigation of Grain Boundary Diffusion in Thin Films by SNMS Technique
- 20 April 2011
- journal article
- Published by Trans Tech Publications, Ltd. in Defect and Diffusion Forum
- Vol. 312-315, 1208-1215
Abstract
It was shown more recently in our Laboratory [1,2,3] that having a substrate/diffusant/thin-film/cap-layer structure (the thin film was typically several 10 nm thick, with the same order of magnitude of grain size; the refractory metal cap layer was used just to avoid the oxidation), first the diffusant atoms migrated very fast across the thin film and segregated at the film/cap-layer interface. The accumulated atoms at the film/cap layer interface form a secondary diffusion reservoir and atoms diffuse back to the layer. Later on, the thin film was gradually filled up with the diffusing atoms and composition depth profiles, determined by Secondary Neutral Mass Spectroscopy (SNMS), showed a maximum at the cap layer-thin film interface. The accumulated atoms at this interface formed a secondary diffusion reservoir and atoms diffused back to the layer. These observations can be interpreted supposing a bimodal grain boundary structure with different (fast and low) diffusivities. The observed grain boundary diffusion phenomena can be classified as C-type diffusion. The appearance of the peak observed at the cap layer interface can be used as a tool to determine the grain boundary diffusivity along the fast boundaries. Because the fast boundaries were saturated in the first stage of the process, this back-diffusion took place along the low-diffusivity boundaries only. Thus the SNMS depth-profiling is a good method to determine grain boundary diffusivities in a bimodal structure. In addition, from the overall impurity content inside the film the segregation can also be estimated, if the bulk solubility is low and the GB density is known. Numerical simulations of C-type GB diffusion in thin films with a bimodal structure confirmed that the interpretation of the result depicted above is reasonable [4]. In order to estimate roughly the GB diffusion data we determined the fast diffusivity using the first appearance method. The lower diffusivity was determined from the time evolution of the broadening of the diffusant/thin film interface. In addition both (slow and fast) diffusivities were also estimated from fitting numerical solutions obtained in [4] too.Keywords
This publication has 13 references indexed in Scilit:
- Investigations of diffusion kinetics in Si/Ta/Cu/W and Si/Co/Ta systems by secondary neutral mass spectrometryVacuum, 2010
- B diffusion in implanted Ni2Si and NiSi layersApplied Physics Letters, 2010
- Subnanometric Si film reactive diffusion on NiApplied Physics Letters, 2009
- Investigations of failure mechanisms at Ta and TaO diffusion barriers by secondary neutral mass spectrometryVacuum, 2009
- Silver grain boundary diffusion in PdApplied Surface Science, 2009
- Grain boundary self-diffusion in α-iron of different purity: effect of dislocation enhanced diffusionZeitschrift für Metallkunde, 2004
- The pressure dependence of grain-boundary diffusion of 65 Zn in polycrystalline aluminiumPhilosophical Magazine A, 1987
- The temperature dependence of grain-boundary diffusion of65Zn in polycrystalline aluminiumPhilosophical Magazine A, 1987
- Grain-boundary diffusion in thin films. II. Multiple grain boundaries and surface diffusionJournal of Applied Physics, 1976
- CXXXVIII. Concentration contours in grain boundary diffusionJournal of Computers in Education, 1954