Design of a Continuous Process Setup for Precipitated Calcium Carbonate Production from Steel Converter Slag
- 27 February 2014
- journal article
- research article
- Published by Wiley in ChemSusChem
- Vol. 7 (3) , 903-913
Abstract
A mineral carbonation process “slag2PCC” for carbon capture, utilization, and storage is discussed. Ca is extracted from steel slag by an ammonium salt solvent and carbonated with gaseous CO2 after the separation of the residual slag. The solvent is reused after regeneration. The effects of slag properties such as the content of free lime, fractions of Ca, Si, Fe, and V, particle size, and slag storage on the Ca extraction efficiency are studied. Small particles with a high free‐lime content and minor fractions of Si and V are the most suitable. To limit the amount of impurities in the process, the slag‐to‐liquid ratio should remain below a certain value, which depends on the slag composition. Also, the design of a continuous test setup (total volume ∼75 L) is described, which enables quick process variations needed to adapt the system to the varying slag quality. Different precipitated calcium carbonate crystals (calcite and vaterite) are generated in different parts of the setup.Keywords
This publication has 18 references indexed in Scilit:
- Impact of alkalinity sources on the life-cycle energy efficiency of mineral carbonation technologiesEnergy & Environmental Science, 2012
- Chemical kinetics modeling and process parameter sensitivity for precipitated calcium carbonate production from steelmaking slagsChemical Engineering Journal, 2012
- Carbon capture and storage using alkaline industrial wastesProgress in Energy and Combustion Science, 2012
- Precipitation of calcium carbonate particles by gas–liquid reaction: Morphology and size distribution of particles in Couette-Taylor and stirred tank reactorsJournal of Crystal Growth, 2010
- Chemical and mineralogical characterizations of LD converter steel slags: A multi-analytical techniques approachMaterials Characterization, 2010
- Steel Converter Slag as a Raw Material for Precipitation of Pure Calcium CarbonateIndustrial & Engineering Chemistry Research, 2008
- Experimental design approach to calcium carbonate precipitation in a semicontinuous processPowder Technology, 2007
- Solubility and structure of calcium silicate hydrateCement and Concrete Research, 2004
- Classification of concentrated suspensions using inclined settlersInternational Journal of Multiphase Flow, 1996
- The effect of electrolytes on bubble coalescence in waterThe Journal of Physical Chemistry, 1993