Abrasive wear resistance of modified X37CrMoV5-1 hot work tool steel after conventional and laser heat treatment
Authors:
- 1 May 2018
- journal article
- research article
- Published by Walter de Gruyter GmbH in International Journal of Materials Research
- Vol. 109 (5) , 460-468
Abstract
The effects of two conventional heat treatments and one innovative processing by laser surface remelting of modified X37CrMoV5-1 tool steel on its abrasion wear resistance were investigated. Conventional heat treatments consisted of quenching from 990 degrees C, individually followed by two different tempering treatments to achieve secondary hardness either at 520 degrees C or 560 degrees C. Laser surface remelting was performed using optimized parameters of continuous laser beam scanning mode. The results showed that the highest wear resistance was obtained for almost carbide-free, surface remelted microstructure with the highest hardness due to microstructural refinement and martensitic transformation hardening. The observed differences in wear resistance among individual material states are discussed in relation to their microstructures, hardness, and wear mechanisms characteristics.Keywords
This publication has 26 references indexed in Scilit:
- Three-body abrasive wear of fine pearlite, nanostructured bainite and martensiteWear, 2013
- Effects of pressure and counterbody hardness in the abrasive wear behavior of tool steelsWear, 2013
- Microstructure and properties of high chrome steel roller after laser surface meltingApplied Surface Science, 2009
- Influences of Co addition and austenitizing temperature on secondary hardening and impact fracture behavior in P/M high speed steels of W–Mo–Cr–V(–Co) systemMaterials Science and Engineering: A, 2008
- Effect of microstructure on slurry abrasion response of En-31 steelMaterials & Design (1980-2015), 2008
- Microstructure and corrosion behavior of laser surface-melted high-speed steelsSurface and Coatings Technology, 2007
- Influence of silicon content on the precipitation of secondary carbides and fatigue properties of a 5%Cr tempered martensitic steelMaterials Science and Engineering: A, 2005
- On the influence of retained austenite in the abrasive wear behaviour of a laser surface melted tool steelWear, 2005
- Failure analysis of a railway copper contact stripEngineering Failure Analysis, 2004
- Stabilisation of retained austenite in laser surface melted tool steelsMaterials Science and Engineering: A, 2004