Effects of thermal treatment on the microstructure and thermal and mechanical properties of poly(lactic acid) fibers
- 28 September 2012
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 53 (5) , 976-981
Abstract
The microstructure and thermal and mechanical properties of poly(lactic acid) (PLA) fibers after thermal treatment under both taut and free conditions at different temperatures were studied by differential scanning calorimetry, wide‐angle X‐ray diffraction, microscopy with polarized light, an acoustic method and tensile testing. In particular, the effects of thermal treatment conditions on crystallinity, molecular orientation, and mechanical properties, as well as their interrelationships, were investigated. Both the crystal orientation and crystallinity of the PLA fibers were higher after thermal treatment under taut conditions, even though the molecular orientation was not higher. Thermal treatment relaxed orientated segments, which resulted in increasing crystallinity; however, it did not indicate that the overall molecular alignment of the chains (molecular orientation) would necessarily be high. Tensile strength and elongation were increased with increasing treatment temperature up to 150°C, which corresponded to crystallinity and chain relaxation. The crystallinity detected by XRD, enthalpy measured by DSC, birefringence, and molecular orientation were compared to distinguish the effects of crystallinity, orientation of polymer chains, and crystals. POLYM. ENG. SCI., 2013. © 2012 Society of Plastics EngineersKeywords
This publication has 43 references indexed in Scilit:
- Thermal behaviour of poly(lactic acid) in contact with compressed carbon dioxidePolymer International, 2009
- Miscibility, melting, and crystallization behavior of poly(hydroxybutyrate) and poly(D,L‐lactic acid) blendsPolymer Engineering & Science, 2008
- Preparation of single poly(lactic acid) compositesJournal of Applied Polymer Science, 2007
- Crystal transformation from the α- to the β-form upon tensile drawing of poly(l-lactic acid)Polymer, 2004
- Preparation of oriented β‐form poly(L‐lactic acid) by solid‐state extrusionJournal of Polymer Science Part B: Polymer Physics, 2001
- Biodegradable self-reinforced composite materials; Manufacturing structure and mechanical propertiesClinical Materials, 1992
- High‐strength poly(L‐lactide) fibers by a dry‐spinning/hot‐drawing process. II. Influence of the extrusion speed and winding speed on the dry‐spinning processJournal of Applied Polymer Science, 1990
- Crystal structure, conformation and morphology of solution-spun poly(L-lactide) fibersMacromolecules, 1990
- Study on the drawing behavior of poly(L‐lactide) to obtain high‐strength fibersJournal of Applied Polymer Science, 1989
- Molecular conformation of poly(S‐lactic acid)Biopolymers, 1968