Optimization of ICPCVD Amorphous Silicon for Optical MEMS Applications
- 6 August 2015
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 24 (6) , 1998-2007
Abstract
In this paper, we present the optimization of optical and mechanical properties of inductively coupled plasma chemical vapor deposited (ICPCVD) amorphous silicon thin films for fabrication of high-quality optical microelectromechanical systems-based devices operating from visible to short-wave infrared wavelengths (450-3000 nm). Our results indicate that, at relatively high deposition temperatures for plasma CVD, a decrease in the ICP power results in films with lower tensile stress, higher refractive index, and lower extinction coefficient. We show that hydrogen concentration alone is not a sufficient parameter for controlling optical and mechanical quality of the films. In particular, both the hydrogen concentration and the hydrogen-silicon bonding nature together play a vital role in determining the optical and the mechanical quality of the silicon thin films. As a demonstration vehicle, three layer silicon-silicon oxide-silicon-based distributed Bragg reflectors were fabricated for the visible (500-700 nm), near infrared (700-1000 nm), and short-wave infrared (2000-3000 nm) wavelength ranges using an optimized silicon fabrication recipe. The measured optical transmission spectra show close to 90% peak reflectivity. Finally, stress optimization was evaluated by fabricating 270-μm diameter circular suspended silicon membranes, which demonstrate a flatness variation on the order of <;6 nm across the entire lateral dimension.Keywords
Funding Information
- Grains Research and Development Corporation
- Australian Research Council Research Grants
- Western Australian State Government Office of Science
This publication has 42 references indexed in Scilit:
- Surface-micromachined silicon air-gap Bragg reflector for thermal infraredJournal of Micromechanics and Microengineering, 2011
- Influence of RF Bias on Hydrogenated Amorphous Silicon by High-Density Plasma Chemical Vapor DepositionJournal of the Electrochemical Society, 2007
- Development of a low temperature MEMS process with a PECVD amorphous silicon structural layerJournal of Micromechanics and Microengineering, 2006
- Surface micromachined optical low-cost all-air-gap filters based on stress-optimized Si3N4layersJournal of Micromechanics and Microengineering, 2005
- Capacitive microphone with low-stress polysilicon membrane and high-stress polysilicon backplateSensors and Actuators A: Physical, 2000
- Improved characteristics of InGaN multiple-quantum-well light-emitting diode by GaN/AlGaN distributed Bragg reflector grown on sapphireApplied Physics Letters, 2000
- Bulk micromachining of siliconProceedings of the IEEE, 1998
- Microstructure and optical absorption properties of Si nanocrystals fabricated with low-pressure chemical-vapor depositionJournal of Applied Physics, 1996
- Determination of the thickness and optical constants of amorphous siliconJournal of Physics E: Scientific Instruments, 1983
- Optical properties and structure of amorphous silicon films prepared by CVDSolar Energy Materials, 1979