Electrochemical Polarization Method to Detect Aging Embrittlement of 321 Stainless Steel
Authors:
- X. MaoXMX. Mao
- 1 April 1993
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 49 (4) , 335-342
Abstract
Type 321 austenitic stainless (UNS S32100) steel boiler tubes used at 550°C for nearly 20 y in power plant are tested by electrochemical polarization. The second anodic current peak increases with service time. The second anodic current peak is caused by the formation of chromium-rich carbides and σ phase at grain boundaries. A normalized second current peak value Ip/Io read from electrochemical polarization curves is used to estimate the aging embrittlement degradation. A close relation between the normalized anodic current density value and the service time is observed. From these results, a nondestructive method for evaluating the degree of aging embrittlement of 321 stainless steel is derived.Keywords
This publication has 9 references indexed in Scilit:
- Microstructural analysis of an embrittled 422 stainless steel stud bolt after approximately 30 years service in a fossil power plantMetallography, 1989
- Hardening and intergranular embrittlement in neutron-irradiated ferritic alloysMaterials Science and Engineering: A, 1989
- Effect of 475.DEG.C embrittlement on fracture resistance of cast duplex stainless steel.Transactions of the Iron and Steel Institute of Japan, 1988
- Temper embrittlement of type 13Cr-4Ni cast steel.Transactions of the Iron and Steel Institute of Japan, 1987
- Small punch test evaluation of intergranular embrittlement of an alloy steelScripta Metallurgica, 1983
- The formation of the σ phase during long term high temperature creep of type 316 austenitic stainless steelMaterials Science and Engineering, 1979
- Mechanism of Intergranular Corrosion and Pitting Corrosion of Austenitic and Duplex 308 Stainless SteelJournal of the Electrochemical Society, 1979
- Phase instabilities during high temperature exposure of 316 austenitic stainless steelMetallurgical Transactions, 1972
- Interpretation of the Second Anodic Current Maximum on Polarization Curves of Sensitized Chromium Steels in 1N H2 SO4Corrosion, 1971