Factors influencing the deposit geometry of experimental turbidity currents: implications for sand-body architecture in confined basins
- 1 January 2004
- journal article
- Published by Geological Society of London in Geological Society, London, Special Publications
- Vol. 222 (1) , 45-58
Abstract
Two sets of scaled laboratory experiments were performed to examine the effect of flow volume, flow density and grain-size distribution on the transport efficiency of turbidity currents. The experiments employed two sediment analogues (ballotini and silica flour) intended to model medium- to coarse-grained sand and mud respectively. In the first set of experiments each parameter was varied to examine its effect upon deposit geometry. Increases in the initial flow density, volume and proportion of fines had the effect of increasing the amount of sediment that was transferred to the floor of the experimental tank by the turbidity currents. Increase of each of these parameters has a characteristic effect on the three-dimensional geometry of the deposit: the deposits of large-volume flows are elongate, and those of fines-rich flows are broad. Increase of flow density increases the initial potential energy of the flow, thus increasing the runout distance; increase of the initial density beyond a sediment concentration of 13% by mass results, however, in a reverse of the geometrical trend of deposit elongation, possibly because of turbulence suppression at high densities. Increase of flow volume also increases the initial potential energy, and reduces the rate of velocity decrease due to gravitational spreading. Increase in the proportion of fines leads to maintenance of negative buoyancy, as the fine fraction remains suspended until the flow has virtually come to rest; it also decreases the settling velocity of the coarser fraction and thus delays its sedimentation. The second set of experiments was performed to investigate the influence of flow efficiency on the interaction of turbidity currents with topography. A single arcuate obstacle was placed in the path of the flows. In successive experiments flow efficiency was increased by progressively increasing the proportion of fines (silica flour). Both the proportion of sediment reaching the obstructing topography and the proportion of it able to surmount the topography increased as flow efficiency increased. Thus flow efficiency may determine whether or not an enclosed basin hosts deposits whose geometry has been affected by the confinement, and may also determine the relative effectiveness of the topography in confining inbound turbidity currents, and thus trapping their sediment load.Keywords
This publication has 36 references indexed in Scilit:
- Coarse-grained and fine-grained turbidite systems as end member models: applicability and dangersMarine and Petroleum Geology, 2000
- Velocity structure, turbulence and fluid stresses in experimental gravity currentsJournal of Geophysical Research: Oceans, 1999
- Experiments on bidisperse, constant‐volume gravity currents: propagation and sediment depositionSedimentology, 1998
- Velocity and turbulence structure of density currents and internal solitary waves: potential sediment transport and the formation of wave ripples in deep waterSedimentary Geology, 1997
- Runout and fine‐sediment deposits of axisymmetric turbidity currentsJournal of Geophysical Research: Oceans, 1995
- Particle-driven gravity currentsJournal of Fluid Mechanics, 1993
- Density surges: two‐dimensional experimentsSedimentology, 1988
- Self-accelerating turbidity currentsJournal of Fluid Mechanics, 1986
- EXPERIMENTS ON DENSITY AND TURBIDITY CURRENTS: I. MOTION OF THE HEADCanadian Journal of Earth Sciences, 1966
- The flow of cohesionless grains in fluidsPhilosophical Transactions of the Royal Society of London. Series A, Mathematical and Physical Sciences, 1956