Effect of Coarse Aggregate Grading on Mechanical Parameters and Fracture Toughness of Limestone Concrete
Open Access
- 27 July 2023
- journal article
- research article
- Published by MDPI AG in Infrastructures
- Vol. 8 (8) , 117
Abstract
This work presents a discussion of the basic properties of broken mineral limestone aggregates with the specification of the properties affecting the fracture toughness of concretes made with these aggregates. To determine the influence of the grain-size distribution of coarse aggregates for each concrete series, two types of aggregate grain were used, with maximum grain sizes of 8 mm (series of concrete L1) and 16 mm (series of concrete L2). Fracture-toughness tests were carried out using mode I fractures in accordance with the RILEM Draft recommendations, TC-89 FMT. During the experiments the critical stress-intensity factor and crack-tip-opening displacements () were determined. The main mechanical parameters, i.e., the compressive strength (fcm) and splitting tensile strength (fctm), were also assessed. Based on the obtained results, it was found that the grain-size distribution of the limestone aggregate influenced the concrete’s mechanical and fracture-mechanics parameters. The obtained results showed that the series-L2 concrete had higher strength and fracture-mechanics parameters, i.e.,: fcm—45.06 MPa, fctm—3.03 MPa, —1.22 MN/m3/2, and —12.87 m10−6. However, the concrete with a maximum grain size of 8 mm (series of concrete L1) presented lower values for all the analyzed parameters, i.e.,: fcm—39.17 MPa, fctm—2.57 MPa, —0.99 MN/m3/2, and —10.02 m10−6. The main reason for the lower fracture toughness of the concretes with smaller grain sizes was the weakness of the ITZ in this composite compared to the ITZ in the concrete with a maximum grain size of 16 mm. The obtained test results can help designers, concrete producers, and contractors working with concrete structures to ensure the more conscious composition of concrete mixes with limestone aggregates, as well as to produce precise forecasts for the operational properties of concrete composites containing fillers obtained from carbonate rocks.
Keywords
This publication has 61 references indexed in Scilit:
- Fracture behaviour of concrete containing limestone finesProceedings of the Institution of Civil Engineers - Construction Materials, 2014
- Experimental Investigation and Numerical Modeling Fracture Processes under Mode II in Concrete Composites Containing Fly-Ash Additive at early AgeSolid State Phenomena, 2012
- The effects of limestone aggregate on concrete propertiesConstruction and Building Materials, 2010
- Mathematical modelling of the interface crack propagation in a pre-stressed fiber reinforced elastic compositeComputational Materials Science, 2009
- Antiplane interface crack in a pre-stressed fiber-reinforced elastic compositeComputational Materials Science, 2008
- Interfacial transition zone in cementitious materialsCement and Concrete Research, 2000
- The examination of the fracture toughness of concretes with diverse structureJournal of Materials Science, 1998
- Determination of fracture parameters (K Ic s and CTODc) of plain concrete using three-point bend testsMaterials and Structures, 1990
- A numerical and experimental investigation for determining fracture toughness of Welsh limestoneMining Science and Technology, 1990
- The investigation of aggregate grain size effect on fracture toughness of ordinary concrete structuresInternational Journal of Fracture, 1989