Use of power factor and specific point energy as design parameters in laser powder-bed-fusion (L-PBF) of AlSi10Mg alloy
Authors:
- Miguel Zavala-ArredondoMZMiguel Zavala-Arredondo
- Tyler LondonTLTyler London
- Madie AllenMAMadie Allen
- Tomaso MaccioTMTomaso Maccio
- Sam WardSWSam Ward
- David GriffithsDGDavid Griffiths
- Amanda AllisonAAAmanda Allison
- Paul GoodwinPGPaul Goodwin
- Carl HauserCHCarl Hauser
Open Access
- 1 November 2019
- journal article
- research article
- Published by Elsevier in Materials & Design
- Vol. 182
Abstract
No abstract availableKeywords
Funding Information
- Horizon 2020
This publication has 29 references indexed in Scilit:
- Parametric analysis of thermal behavior during selective laser melting additive manufacturing of aluminum alloy powderMaterials & Design (1980-2015), 2014
- Power factor model for selection of welding parameters in CW laser weldingOptics & Laser Technology, 2014
- Effect of Layer Thickness in Selective Laser Melting on Microstructure of Al/5 wt.%Fe2O3Powder Consolidated PartsThe Scientific World Journal, 2014
- Selective laser sintering/melting (SLS/SLM) of pure Al, Al–Mg, and Al–Si powders: Effect of processing conditions and powder propertiesJournal of Materials Processing Technology, 2013
- Additive manufactured AlSi10Mg samples using Selective Laser Melting (SLM): Microstructure, high cycle fatigue, and fracture behaviorMaterials & Design (1980-2015), 2012
- Mechanical Properties of AlSi10Mg Produced by Selective Laser MeltingPhysics Procedia, 2012
- Direct photonic production: towards high speed additive manufacturing of individualized goodsProduction Engineering, 2011
- Selective laser melting of aluminium componentsJournal of Materials Processing Technology, 2011
- High Power Selective Laser Melting (HP SLM) of Aluminum PartsPhysics Procedia, 2011
- Single track formation in selective laser melting of metal powdersJournal of Materials Processing Technology, 2010