The effects of radio-frequency bias on electron density in an inductively coupled plasma reactor
Authors:
- 1 December 2007
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 102 (11) , 113302
Abstract
The effect of radio-frequency bias on electron density in an inductively coupled plasma reactor was measured using a wave cutoff probe, over a wide range of conditions in pure Ar, pure , and 50%–50% mixtures of , at pressures of , bias frequencies of , bias voltages up to , and inductive source powers of . Also, at selected experimental conditions, comparisons with Langmuir probe measurements were made. Two types of bias-induced changes in electron density were detected. First, at high source powers, we observed a bias-induced decrease in electron density, which had a slow time response (several minutes), a linear dependence on bias voltage, and little or no dependence on bias frequency or pressure. This decrease is a gas composition effect caused by etch or sputter products liberated from the wafer surface. Second, at low source powers, we observed a faster, bias-induced increase in electron density, which was proportional to the bias frequency and the square root of the bias voltage. This second effect was caused by absorption of bias power by electrons via stochastic heating. Simple models of each effect were derived and were shown to yield quantitative predictions in agreement with the observations. To obtain correct predictions, the effect of bias-induced electron heating cannot be considered by itself; rather, its effect on the efficiency of the inductive source must also be considered.
Keywords
This publication has 44 references indexed in Scilit:
- Self-Consistent Particle Modeling of Inductively Coupled CF4 Plasmas: Effect of Wafer BiasingJapanese Journal of Applied Physics, 2006
- The etching of silicon carbide in inductively coupled SF6/O2plasmaJournal of Physics D: Applied Physics, 2003
- Charged species dynamics in an inductively coupled Ar/SF6 plasma dischargeJournal of Applied Physics, 2002
- Characterization of inductively coupled plasma using neural networksIEEE Transactions on Plasma Science, 2002
- Deep etch of GaP using high-density plasma for light-emitting diode applicationsJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 2002
- High-density plasma-induced etch damage of wafer-bonded AlGaInP/mirror/Si light-emitting diodesJournal of Vacuum Science & Technology A, 2002
- Etching characteristics and plasma-induced damage of high-k Ba0.5Sr0.5TiO3 thin-film capacitorsJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 2001
- Transient plasma-induced emission analysis of laser-desorbed species during Cl2 plasma etching of SiJournal of Vacuum Science & Technology A, 2000
- Langmuir probe studies of a transformer-coupled plasma, aluminum etcherJournal of Vacuum Science & Technology A, 1999
- Comparison of advanced plasma sources for etching applications. II. Langmuir probe studies of a helicon and a multipole electron cyclotron resonance sourceJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 1994