Fabrication and analysis of palmitic acid–decanoic acid@Ce–Eu/TiO2 composite as a building material for regulating indoor environment
- 8 September 2020
- journal article
- research article
- Published by Wiley in Asia-Pacific Journal of Chemical Engineering
- Vol. 16 (1)
Abstract
Novel palmitic acid–decanoic acid@Ce–Eu/TiO2 (PA–DA@Ce–Eu/TiO2) microspheres with high photocatalysis–thermal–humidity collaborative performance were prepared via a two‐step method. Ce and Eu were used for codoping to modify the TiO2 hollow microspheres to enhance the photocatalytic properties. Furthermore, a eutectic phase change material (PA–DA) was combined with Ce–Eu/TiO2 hollow microspheres to prepare PA–DA@Ce–Eu/TiO2 microspheres. X‐ray diffraction and UV–VIS spectral analyses proved that Ce–Eu codoping enhanced the photocatalytic properties of the PA–DA@Ce–Eu/TiO2 microspheres under solar light; the degradation rate to gaseous formaldehyde at low concentrations reached 54.98% after 5 h. The pore structure, particle size distribution, microstructure, and thermostability of the PA–DA@Ce–Eu/TiO2 microspheres were determined using N2 adsorption isotherms, laser scattering particle size distribution analysis, scanning electron microscopy, and thermogravimetric analysis, respectively. The results showed that the Ce–Eu/TiO2 microspheres had a typical mesoporous structure, concentrated particle size distribution, and rough surface. The porous structure of the PA–DA@Ce–Eu/TiO2 microspheres was conducive to adsorb/desorb moisture, which was recorded to be 0.0575 g/g at 43.16–75.29% relative humidity. The differential scanning calorimeter analysis showed that the phase transition temperature of the PA–DA@Ce–Eu/TiO2 microspheres was 20–22°C and that the PA–DA@Ce–Eu/TiO2 microspheres were stable at 35°C. After 300 thermal cycles, the heat storage capacity of the PA–DA@Ce–Eu/TiO2 microspheres decreased by only 5%. Thus, we concluded that the PA–DA@Ce–Eu/TiO2 microspheres can purify air and control indoor thermal and humidity environments simultaneously and hence can be used as functional building materials to adjust the indoor environment.Keywords
Funding Information
- National Natural Science Foundation of China (51978002)
This publication has 45 references indexed in Scilit:
- Measurement of freezing point of tilapia fish burger using differential scanning calorimetry (DSC) and cooling curve methodJournal of Food Engineering, 2015
- Evaluation of performance and moisture sensitivity of glasphalt mixtures modified with nanotechnology zycosoil as an anti-stripping additiveConstruction and Building Materials, 2015
- Microstructural characterization of Cu/Al composites and effect of cooling rate at the Cu/Al interfacial regionInternational Journal of Minerals, Metallurgy and Materials, 2015
- Experimental investigation on thermal and rheological properties of n-octadecane with dispersed TiO2 nanoparticlesInternational Communications in Heat and Mass Transfer, 2014
- Effect of the addition of Ce to MnOx/Ti catalyst on reduction of N2O in low‐temperature SCRAsia-Pacific Journal of Chemical Engineering, 2014
- A facile and low-cost synthesis of granulated blast furnace slag-based cementitious material coupled with Fe2O3 catalyst for treatment of dye wastewaterApplied Catalysis B: Environment and Energy, 2013
- Concurrent Aggregation and Deposition of TiO2 Nanoparticles in a Sandy Porous MediaEnvironmental Science & Technology, 2010
- Enhanced photocatalytic activity of silica-embedded TiO2 hollow microspheres prepared by one-pot approachJournal of Alloys and Compounds, 2010
- Moisture performance of building materials: From material characterization to building simulation using the Moisture Buffer Value conceptBuilding and Environment, 2009
- Granular phase changing composites for thermal energy storageSolar Energy, 2005