Improvements to close coupled gas atomisation nozzle for fine powder production
Author:
- 1 March 2007
- journal article
- Published by SAGE Publications in Powder Metallurgy
- Vol. 50 (1) , 66-71
Abstract
In the present study, a new close coupled annular slit type nozzle was designed and constructed to produce metal powders in order to investigate the improvement of efficiency of fine powder production. The atomisation runs for the present study were performed with a small scale close coupled gas atomisation system designed and constructed at the Mechanical Engineering Department of Dumlupinar University. Pure tin powders were produced using nitrogen gas. The effects of the atomisation gas pressure on the backpressure and powder size have been discussed. The present atomisation runs showed that particle size decreased as atomising gas pressure increased. The particle size was reduced from 55·4 to 12·9 μm with increasing pressure from 0·9 to 3·1 MPa. The mass median particle sizes decreased continuously from 55 μm at a G/M of 0·22 to 12·9 μm at a G/M of 1·36 with increasing G/M ratio. Above a certain G/M , the resultant particle sizes cannot be considerably reduced by further increasing atomising pressure.Keywords
This publication has 7 references indexed in Scilit:
- The influence of the pressure formation at the tip of the melt delivery tube on tin powder size and gas/melt ratio in gas atomization methodJournal of Materials Processing Technology, 2006
- Effects of gas pressure and protrusion length of melt delivery tube on powder size and powder morphology of nitrogen gas atomised tin powdersPowder Metallurgy, 2006
- High-speed cinematography of gas-metal atomizationMaterials Science and Engineering: A, 2005
- The effect of wake-closure phenomenon on gas atomization performanceMaterials Science and Engineering: A, 2002
- Investigations on melt atomization with gas and liquefied cryogenic gasMaterials Science and Engineering: A, 2002
- Production of High Strength Al—Mg—Sc Alloys by PMPowder Metallurgy, 1998
- Flow mechanisms in high pressure gas atomizationMaterials Science and Engineering: A, 1991