Experimental investigation of the quasi-static and impact tests on the energy absorption characteristics of coupler rubber buffers used in railway vehicles
- 28 December 2018
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit
- Vol. 233 (9) , 937-950
Abstract
Coupler rubber buffers are widely used in high-speed trains, to dissipate the impact energy between vehicles. The rubber buffer consists of two groups of rubbers, which are pre-compressed and then installed into the frame body. This paper specifically focuses on the energy absorption characteristics of the rubber buffers. Firstly, quasi-static compression tests were carried out for one and three pairs of rubber sheets, and the relationship between the energy absorption responses, i.e. Eabn = n × Eab1, Edissn = n × Ediss1, and Ean = Ea1, was obtained. Next, a series of quasi-static tests were performed for one pair of rubber sheet to investigate the energy absorption performance with different compression ratios of the rubber buffers. Then, impact tests with five impact velocities were conducted, and the coupler knuckle was destroyed when the impact velocity was 10.807 km/h. The results of the impact tests showed that with the increase of the impact velocity, the Eab, Ediss, and Ea of the rear buffer increased significantly, but the three responses of the front buffer did not increase much. Finally, the results of the impact tests and quasi-static tests were contrastively analyzed, which showed that with the increase of the stroke, the values of Eab, Ediss, and Ea increased. However, the increasing rates of the impact tests were higher than that of the quasi-static tests. The maximum value of Ea was 68.76% in the impact tests, which was relatively a high value for the vehicle coupler buffer. The energy capacity of the rear buffer for dynamic loading was determined as 22.98 kJ.Keywords
Funding Information
- The National Natural Science Foundation of China (51675537)
- the National Key Research Project of China (2016YFB1200404-04)
This publication has 19 references indexed in Scilit:
- Analysis and parameters optimization of an expanding energy-absorbing structure for a rail vehicle couplerThin-Walled Structures, 2018
- Numerical and experimental study of wheel-rail impact vibration and noise generated at an insulated rail jointInternational Journal of Impact Engineering, 2018
- The impact performance of honeycomb-filled structures under eccentric loading for subway vehiclesThin-Walled Structures, 2018
- Frontal collision of trains onto obliquely stuck road trucks at level crossings: Derailment mechanisms and simulationInternational Journal of Impact Engineering, 2017
- Development issues for impact safety of rail vehicles: Robustness of crashworthy designs, effect of structural crashworthiness on passenger safety and behaviour characterisation of vehicle materialsProceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit, 2016
- Modelling aspects of the design of railway vehicle structures and their crashworthinessProceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit, 2015
- Compressed stability analysis of the coupler and buffer system of heavy-haul locomotivesVehicle System Dynamics, 2015
- A review of dynamics modelling of friction draft gearVehicle System Dynamics, 2014
- Coupler dynamic performance analysis of heavy haul locomotivesVehicle System Dynamics, 2012
- Numerical study of the noninertial systems: application to train coupler systemsNonlinear Dynamics, 2011