Study on hot deformation behaviour and microstructure of Zr-4 alloy
Authors:
- Xuan ZhouXZXuan Zhou
- Kelu WangKWKelu Wang
- Xin LiXLXin Li
- Xiayun GaoXGXiayun Gao
- Mingjun ZhongMZMingjun Zhong
- Rui FengRFRui Feng
Open Access
- 1 March 2020
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 768 (2)
Abstract
The isothermal compression experiment of Zr-4 alloy was accomplished by using Gleeble-3500 thermomechanical simulator. The hot deformation behaviour at the strain rate of 0.001~10s-1 and the deformation temperature of 750~1000°C was researched. The characteristics of flow stress were studied. The result is that the flow stress has a great influence on the deformation temperature and the strain rate. Based on the experimental data, the strain rate sensitivity map (m) was established. Through microstructure observation, the zones at lower m value are mainly flow localization (750 °C/10s-1) and kink (950 °C/10s-1). The zones at higher m value are mainly spheroidization. The result is that at strain rate of 0.01~0.1s-1/deformation temperature of 900~1000 °C is the suitable deformation parameter of Zr-4 alloy.Keywords
This publication has 7 references indexed in Scilit:
- Effects of initial microstructure on hot deformation behavior of Al-7.9Zn-2.7Mg-2.0Cu (wt%) alloyMaterials Characterization, 2019
- Microstructural and textural evolution during hot deformation of dilute Zr-Sn alloyJournal of Nuclear Materials, 2016
- Constitutive Modeling and Hot Deformation Behavior of Duplex Structured Mg–Li–Al–Sr AlloyJournal of Materials Science & Technology, 2016
- Effect of strain rate on twinning in a Zr alloyScripta Materialia, 2014
- Materials challenges in nuclear energyActa Materialia, 2013
- Role of twinning in the hardening response of zirconium during temperature reloadsActa Materialia, 2006
- The development and applications of zirconium alloysMaterials & Design (1980-2015), 1985